Need to know what color are the wires to hook into for IAT into ecu on 91 Chevrolet Corsica?
I signed up on ALLDATA.COM for my Corsica, it is an online tech manual just for your car, it has diagrams, exploded view and just about everything you can imagine for your vehicle. T HEMPLE
What color are the wires that you need to remove on a 2001 Chevrolet Silverado to disable the door ajar warning?
What color are the rear speaker wires in a 2001 Volvo s60 t5 so you can splice in a connection for a system?
1995 Chevy Beretta it runs fine until you put it gear and then it starts missing i need to know where the tcc solinoid is located and what color wires to cutIt has a 3.1 in it thanks?
What wires do you need to cross on a 1991 ford explorer on the safety switch to make it turn over after switching from auto to manual you just need the color please?
1989 Chevrolet corsica 2.8 engine engine will not start have plenty of gas spark to plugs electric supply to imjecters?
Double check to make sure you have your spark plug wires in the correct order. If they're out of order (on the wrong plugs) the plugs will fire, but not in the correct order to ignite the fuel. If the wires are on in the correct order, check your ignition timing. Incorrect timing could also cause an engine with fuel and spark to not run. For references on how to check your timing, and what…
What 2 color wires do you need to put a simple push button starter in and do you tie into those 2 wires or cut them and go directly to your button?
Looking for a wiring diagram for a remote start the name of it is command start my 93 Chevrolet truck will not start with remote?
Your 94 3.1 v6 corsica won't start the starter cranks and will give a a quick sputter but wont fire up any thoughts to what this might be?
How to determine wires to cut at ignition switch for remote start need color for wire to starter motor and primary ignition?
The ground wire on a typical Chevrolet truck should be located at the rear of the vehicle. The wire should be white in color, and should be attached to the frame by a screw. You may need to remove the tail light housing and trace the wire from there as the location varies on different models and years.