Try the Brake Light Switch it should be located under the dash where the brake pedal arm attachs and pivots.
Good Luck and Remember.
Change Your Mind, Not Your Oil.
Use the First In Synthetic Motor Oil's.
See My Bio For more information.
Also check the multifunction switch in the steering column. These are notorious for shorting out in the sunfires/cavaliers. Manufacturer number: ARBC505802, AutoZone part #SW824, shoud cost you about $40 and is easy to replace. Tip: try jiggling the hazard light switch on the steering column and see if you get any activity in the brake lights.
check your fuses first, then check your bulbs and then your relay.
You need new bulbs
check your bulbs and fuses check your bulbs and fuses
check your fuses?
have you checked the bulbs and fuses
on some cars the tail lights and brake lights are totally different bulbs gain access to the bulbs and have someone push the brakes so that you can determine which bulbs are the brake lights and replace the tail lights
fuses are blown, or bulbs are blown
Have you checked the fuses and bulbs?
The most common reason that your dash lights and taillights are not working on your Pontiac Grand Am is blown fuses. Replace the fuses.
you should try checking the fuses and replacing the bulbs the fuses for thos lights should only be about a 10 or a 15
Working brake lights are important for safety reasons while driving. It is important to check all of the wiring, if the brake lights are not working and the fuses and bulbs have been checked.
It should be in the fuse panel with all of the rest of the fuses.
AnswerThe bulbs for the brake lights are usually separate from the normal tail light bulbs. Check and replace the brake bulbs first, and if they are still not working examine the fuses, switch and wiring.
They are two separate circuits. Check the bulbs and fuses first.
The brake lights are a separate circuit from the other lights. Check the fuses and bulbs. If fuses and bulbs are okay I would suspect the brake light switch is at fault.
check bulbs, fuses & reverse switch
If the bulbs and fuses are fine, it must be your brake light switch attached to the arm on your brake pedal.
First check the fuses then change the bulbs it is posable for both to go out
Start by checking fuses Then check the light bulbs Some Bonnevilles have “Cluster lights” These should be checked by a dealership or a qualified mechanic
Check bulbs, fuses and brake switch in that order.
Brake Lights not Stop Lights. Check your Fuses then the Bulbs. Hope This Helps.
Start small. Check your fuses.
If the parking/tailight fuse is good - then it may be a bad headlight switch No tail lights but the bulbs are working? Please explain.
Check all the fuses. If not bulbs or switch that's all that it can be,
98 sierra1500 4x4 all lights work excepttail lights fuses are good bulbs are new