Car Fuses and Wiring
Headlights Tail and Brake Lights
1995-2005 Chevy Cavaliers

No brake lights on 93 Chevrolet S10 you have replaced bulbs fuse and switch?

181920

Top Answer
User Avatar
Wiki User
2007-04-08 06:10:03
2007-04-08 06:10:03

blinker switch is part of that system is most likey problem trust me i owned 9 s10 all 82-94 and college for 5 years of elec/auto replace the blinker switch on the clolume"

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Check the brake switch located on your brake pedal shaft. May have to be replaced.

User Avatar

have power to fuse box but not brake lgt switch new bulbs all wiring ckd brklgt switch replaced. this should be up with my question new here oops

User Avatar

Out of adjustment. Adjust the mounting of the switch so the brakes lights are off until you press the brake pedal.

User Avatar

i have tail lights but do not have brake lights nor do i have turn signals. i have replaced brake switch and all bulbs

User Avatar

The turn signal switch overrides the brake light circuit while the turn signals are on. If the switch is damaged or worn out the brake lights won't work.

User Avatar

Check the brake light fuse. If you have 12 volts at the brake light switch I would suspect the signal light switch is at fault.

User Avatar

The BOO (Brake On/Off) Switch may need to be replaced. If it is bad, it would cause the brake lights to NOT illuminate when the brake pedal is applied.

User Avatar

"Stuck" brake lights indicate that the brake light switch on the brake pedal is broken. It should be replaced.

User Avatar

The brake lights won't turn off because the brake light switch on the pedestal of the brake pedal needs to be replaced.

User Avatar

If you have the same bulb for brake and signal, brake light power needs to be interrupted by the signal lights, The brake circuit has to go through the signal light switch so the problem could be there.

User Avatar

Check the brake light switch. This can cause the brake lights to go out. There have been a couple of recalls on the 2001 for this exact problem. Contact your local VW dealer and have the switch replaced.

User Avatar

Switch on brake pedal needs tightened replaced, or switch for lights needs tightened or replaced.

User Avatar

check the wires at brake light switch on brake pedal they are bad about breaking brake light switch

User Avatar

When break lights do not turn off when the brake pedal is fully retracted suggests two possible causes: * The brake light switch is out of adjustment and needs to be adjusted. * The brake light switch is defective and needs to be replaced.

User Avatar

the brake light switch on the brake pedal is bad and needs to be replaced. A $10.50 part at parts store.

User Avatar

The problem points to the directional/lights and hazard switch. The brake light wiring is part of that circuit.You can buy the switch after market it is about $70.00.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.