Oil and Oil Filters
Jeep Liberty
Jeep Liberty Sport

Oil light in Jeep Liberty will come on after driving for 10 minutes?

565758

Top Answer
User Avatar
Wiki User
2005-11-08 05:57:08
2005-11-08 05:57:08

May have a loose wire on the oil sender . There might be too much oil is says right on the dipstick do not overfill Keep it in the SAFE area

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

How do you reset engine light on jeep liberty diesel

User Avatar

what is this code p1491 on 2003 jeep liberty

User Avatar

See sources and related links below for the 2004 Jeep Liberty Brake Light Lamp Numbers.

User Avatar

w to replace center brake light in 2004 jeep liberty

User Avatar

See the amswer for "How do you change the rear stop light bulb on a 2002 Jeep Liberty passenger side". It works.

User Avatar

Did not receive a owners manual when I purchased my Jeep Liberty 2004. There is a warning light that looks like a transmission lighting up - what does it mean?

User Avatar

You may need to check the oil, or have the jeep serviced.

User Avatar

Try disconnecting the battery for about 10 minutes or have vehicle scanned to determine problem and have codes cleared

User Avatar

disconnect battery for at least 10 minutes that should reset computer code

User Avatar

Jeep Liberty was created in 2001.

User Avatar

With a scan tool, or unhook the battery for 5 minutes

User Avatar

Yes. The Liberty is made by Chrysler under the Jeep brand.

User Avatar

The 2006 Jeep Liberty rear tail light lens does not come off. The tail light is seal. You can access the tail light lightbulb through the back of the tail light, in the cargo compartment.

User Avatar

3000-7500 miles depending on driving conditions.

User Avatar

The dome light fuse on a 2003 Jeep Liberty can be changed by first locating the fuse panel near the hood release. The dome light fuse can then be pulled from its socket and a new fuse put in place.

User Avatar

Have vehicle scanned to determine the problem

User Avatar

replace rear tail light bulb

User Avatar

The oil light in a Jeep Liberty can be reset. To reset the light turn the ignition switch on or off without starting the engine. Next depress the acceleration pedal at least three times and then switch the ignition switch in a locked position.

User Avatar

how much is my jeep liberty worth

User Avatar

It is not a light, but a decal or printed type. It is a specification, I believe. Has nothing to do with a warning or message.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.