Head Gaskets and Valve Covers
Antifreeze and Engine Coolant
Ford Expedition Eddie Bauer
Late Model 1979-New Ford Mustangs

On a 1987 mustang gt coolant is leaking into oil but its not the head gasket?

567

Top Answer
User Avatar
Wiki User
Answered
2011-09-13 12:29:31
2011-09-13 12:29:31

Intake manifold is leaking, or worse, cracked cylinder most likely tho, the intake manifold.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


2 possibilities.....1 your ac evaporator drain is plugged and needs to be cleaned out. 2 if it is coolant your heater core his leaking.


Possibilities are low coolant, defective radiator, leaky hoses, blown head gasket...




The 1987 Ford Mustang came with a T-5 five-speed manual or optional automatic transmission.


To repair the head gasket on a 1987 Ford Bronco, the head and the old gasket must be removed. Purchase a new head gasket and carefully install it according to manufacturer specifications.


it will not work the wires and connectot are different


where is the coolant temperature sensor locate


Overheating checklist 1. Low coolant 2. Thermostat stuck closed 3.air trap in coolant system (drain system, try to raise car on angle that would allow air to escape when filing, lift front end up run engine to circulate. 4. Ignition timing to far advanced 5. Head Gasket leaking exhaust into water jacket 6. Cracked head


( 210 horsepower from the factory ) for the 1987 Ford Mustang GT with the 302 ( 5.0 liter ) high output . The 8th " character " of the VIN is an " M "


Yes they are exactly the same door assembly from 79-93



Motorweek - 1987 Ford Mustang Bullit 27-26 was released on: USA: 29 February 2008


Check the bottom of the radiator for damage. The coolant light will go on when the fluid level drops too low. Check the reservoir and add as necessary.


"Engine Coolant Temperature" sensor.


head gasket gone, depending on where the gasket fails determins the visual affects of gasket failure


The gasket is between the head and the manifold and simply remove the bolts and replace the gasket after cleaning it real good.




what about it? are you looking for the where abouts?


Into the transmission fluid reservior


A STOCK 1987 Ford 5.0 Mustang GT Cobra has 225 HP (horsepower) @ 4000RPM and 300 lb/ft torque @ 3000 RPM. i hope i helped :)


undo the motor mounts and loosen the tranny mount lift the engine upwards slowly and carefully. remove pan bolts and old gasket.do revers for install .toque to corret specs.


210 horsepower at 4400 RPM and 265 ft.lbs torque at 3200 RPM for the 5.0 L - HO in a 1987 Ford Mustang according to my Chilton auto repair manual


Check to see if coolant is mixing with engine oil. Run engine to normal operating temperature and remove oil dipstick, let a drop of fluid fall onto a hot part of engine, oil will smoke and coolant will sizzle. If coolant is into engine oil could be a sign of a bad head gasket If fluid level is correct, but still overheating, could be: Thermostat is not opening Water pump not circulating coolant Cooling fan not working



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.