0
On a 1997 ford ranger 3.0 engine the coolant temp sending unit in in a housing with a tube for a hose what is it called?
Wiki User
∙ 13y ago
I BELIEVE that is called the ( engine coolant thermostat / water outlet assembly )
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Where is the Coolant temperature sending unit located on a 1997 camaro 3.8l?
The 1997 Chevrolet Camaro 3.8 liter engine coolant temperature sending unit can be found on the front of the engine. The coolant temperature sending unit will be approximately 3 inches above the thermostat housing.
Where is the water temperature sensor located on a 1995 Aerostar 4.0 liter?
Follow the top radiator hose to the engine. Where the hose is attached to the engine is the thermostat housing. On the left side of the housing, is the Coolant temperature sending unit to the gauge, and on the right side, there is EEC-IV coolant temperature sending unit to the computer. ( when you are standing at the front of the vehicle )
Engine Coolant Temperature Sensor?
The engine coolant temperature sensor is usually on the front of the engine. The coolant temperature sensor will be in the vicinity of the thermostat housing.
Where is the coolant temperature sending unit on a 2005 ford ranger?
The Engine Coolant Temperature sensor can be found near the thermostat housing or close to where the upper radiator hose attaches to the intake manifold. Good luck.
Where is temp sending unit on 2004 ford ranger?
The Cylinder Head Temperature (CHT) sensor for the 2.3L engine is located between the two center ignition coils. The Engine Coolant Temperature (ECT) sensor for the 3.0L engine is located in the intake manifold to the right of the thermostat housing. The Engine Coolant Temperature (ECT) sensor for the 4.0L engine is located in the intake manifold behind the thermostat housing.
Where is temp sensor in a 94 ford v6?
The coolant temperature sending unit for your engine temperature gauge is located on the intake manifold just to the left of the thermostat housing ( when looking from the front of the Explorer ) The larger sending unit to the right of the thermostat housing is for the EEC - IV system
Where is the coolant sensor in a 98 grand am?
sensor is located on coolant housing at engine front
What causes your 1990 Chevy to receive to much gas to the throttle body?
Replace the engine coolant sensor, the one next to the thermostat housing. It could be sending the wrong signal to the ecm that the engine is still cold.
Where is the coolant temperature sensor on a 1996 ford explorer?
On the 4.0 L - OHV - V6 engine , follow the top radiator hose from the radiator to the engine where the thermostat housing is . There should be 2 coolant temperature sending units . I believe the smaller one on the left ( looking from the front ) is for your engine coolant temperature gauge and the larger one on the right is for the EEC - V system
Location of a 97 coolant ford explorer temp sensor?
On my 1995 with the 4.0 L OHV engine, the coolant temperature sending unit for the temperature guage is located on the intake manifold just to the left of the thermostat housing when standing in front of the vehicle. The larger sending unit on the right is for the EEC system.
How do you replace thermostat on 1992 buick lesabre?
Open the Century's hood. Follow the upper radiator hose from the engine to the coolant outlet housing, on the upper portion of the engine's side.Remove the bolts holding the coolant outlet housing to the engine, using a socket wrench and an 8 mm socket.Pull the coolant outlet housing off the engine, by hand. Shove a rag into the outlet housing to prevent debris from entering the engine.Clean the sealing surface on the engine and housing, using a gasket scraper.Remove the rags from the engine and coolant outlet housing. Start the engine and let it run until the temperature gauge reaches operating temperature.
Where is the temp sending unit for a 1999 ford explorer xls 4.0 w over head valves?
Your coolant temperature sending units for your temperature gauge and EEC - V system should be on either side of your thermostat housing at the front of your intake manifold on the 4.0 L OHV engine . ( where the top radiator hose connects to the engine ) When looking from the front of the engine , I believe the sending unit for your temperature gauge is the smaller one to the left of the thermostat housing.
