I don't think repairing is possible.replacing is the best bet.
I believe it is a pressure hose and just like the Power Steering hose if they deteriorate they just need to be replaced.
If in an emergency situation to get you somewhere to have repairs done I would try Duct Tape...
If cost is a problem try your local auto dismantler or wrecker, I buy used parts for my Honda and havent been let down yet.
how do you drain s 1999 olds cutlass radiatoe
get a chiltons repair manual from the library for your car.
According to my 99 Cutlass Owners Manual, the capacity is 15 gallons.
The 1999 Oldsmobile Cutlass OBD 2 port is under driver side dash left of steering column
On a 1999 Olds Cutlass, the water pump is located in the engine compartment under the hood. It is on the motor on the passenger side of the vehicle.
bad camshaft position sensor
i dont have a answer i want a answer
what is a 1998 olds moblie cutlass value
where is the emc located on a 1988 olds cutlass?
Where is the water pump on a 1995 olds cutlass supreme?"
You can't, you have to get it serviced after 100,000 miles..Yes I know it is stupid.
i need to replace the ecm on a 1993 olds cutlass supreme,can i replace it with another ecm from another olds cutlass?
Any parts store should be able to fix you up.
how do you replace a starter on a 1998 cutlass
( .040 inch ) according to my Chilton repair manual for the 350 - 2 barrel
The last rwd Olds Cutlass was the 1988 model.
Remove the wiper arm from your 1999 Oldsmobile Cutlass wiper motor. Remove the wiper motor wiring harness. Remove the wiper motor retaining bolts. Reverse the process to install the new wiper motor.
I've had problems with the Intake Manafold and also with the spark plug towers burning out setting off the check engine light. I know there are more but this is just my personal experience with my 1999 cutlass.
I have a 1998 olds cutlass and it is leaking cooling and have a bad ticking sound what do you think I should do.
An exploded view of the heater controls for a 1989 Olds Cutlass can be found in the Cutlass service manual. The manual can be found at most auto parts.
It is in the fuel tank so the tank has to be dropped, tank cover unscrewed, and fuel pump extracted and replaced.
The temperature sensor on a 93 Olds Cutlass Cierra 3.3 is located on the back of the engine. It is on the intake manifold.
I am trying to take the motor out of a 95' Olds cutlass supreme. The trans. is giving me problems. How many bolts hold it in.
To replace the transmission fluid in the 1999 3100 V-6 Olds Cutlass, first remove the transmission drain plug from the underside of the vehicle. Drain all of the old fluid. Then, replace the drain plug and add new fluid through the transmission dipstick holder in the engine compartment.