answersLogoWhite

0


Top Answer
User Avatar
Wiki User
Answered 2008-08-19 19:15:43

Yes you do need to remove the inner mud shields from the fenderwell and also the tire not a simple thing to do on the side of the road or in the driveway (should take it to a local shop Yes you do need to remove the inner mud shields from the fenderwell and also the tire not a simple thing to do on the side of the road or in the driveway (should take it to a local shop As everyone says, it is much better to raise the vehicle and remove the left front tire along with the mud shields. The battery may have a heat shield around it. Don't tear it up. It can be reused. My battery lasted six years and just died right in the middle of the Chrysler dealers drive in shop. I had them jump it and was able to drive it home with the bad battery. If that happens to you, just keep the engine rpm up above 1500 rpm and don't turn anything on or the engine will die and you will be left sitting on the side of the road. New six year battery at Walmart was 68.00. Would have been 168.00 at the dealer.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Loading...

Still have questions?

Related Questions

How do you change the battery on a 2001 Chrysler Sebring?

it is very easy to change the battery on a 2001 Chrysler Sebring. You just need to take the battery terminals off the old battery and then replace with the new battery. Make sure to replace the terminals on the correct battery post.


Why wont your 2004 Chrysler sebring start up after you replace the battery?

Because you didn't charge the battery.


How do you replace the starter on a 2001 Chrysler Sebring convertible?

Remove the positive battery cable from your 2001 Chrysler Sebring battery. Remove the cables from the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.


How do you replace a Chrysler Sebring 2001 Cabin Filter?

A 2001 Chrysler Sebring does not have a cabin filter.


Ignition switch will not turn Replace?

Ignition switch 2002 Chrysler sebring. Original key will not turn? Is there a fuse or replace the switch?


How do you make the negative battery cable on a 1999 Chrysler Sebring longer?

Replace it with a longer cable. That is the safest and best way. You could splice another cable on to the original but I would not advise it.


How do you replace the battery in a 2003 Chrysler Sebring?

Remove driver side front tire. Remove inner fender liner. Remove battery. Reverse steps.


Chrysler sebring ignition damage by thief key doesn't work how do you replace?

Chrysler sebring ignition damage by thief key doesn't work how do you replace?"


Can you replace an 2.7 Chrysler engine in a 2006 sebring with an 3.2?

No, the 3.2L will not fit a Sebring.


How do you replace the transmission solenoid pack on a 1998 Chrysler Sebring Convertible?

To replace the transmission solenoid pack on a 1998 Chrysler Sebring, remove the air filter box, the battery, and the battery tray. Remove the 4 bolts on the frame and the trans cooler lines. The solenoid pack is screwed to the to the transmission with 3 10 mm bolts. Remove the solenoid pack and replace it.?æ


How to replace push rods on a 2002 Chrysler sebring gtc?

A 2002 Chrysler Sebring has an overhead cam engine. That means it does not have push rods.


Can you replace the battery of a 2004 Chrysler Sebring Touring without taking off the tire?

Unfortunately, you have to remove the wheel to access the battery.


How do you replace the battery on a 2000 Chrysler Sebring?

AnswerThe battery located inside wellwheel on driverside, turn wheel all the way to the right open the well wheel cover,battery inside fender comparment.


How do you fix code p1492 on 96 Chrysler Sebring?

P1492 Battery Temperature Sensor Voltage Too High Test and/or replace the battery temp sensor. It is usually located under or near the battery.


Where is the battery located on a 2004 Chrysler sebring?

2000 Chrysler sebring,to replace battery car must go to dealer to have fender removed so new battery can be installed, they charge $169.00 for this work. Or they remove it through the hatch in the wheel well. Turn wheel fully left. Disconnect terminals. Remove the panel from the left wheel well. Remove the battery hold-down


What does it cost to replace crankshaft sensor on Chrysler sebring 1999?

60.00 $


How much should it cost to replace the rack and pinion on a 1996 Chrysler Sebring?

It will cost between $300.00 to $500.00 to replace the rack and pinion on a 1996 Chrysler Sebring. This cost includes labor and parts.


What does it cost to replace a carburetor on a 2004 Chrysler Sebring?

It would be very expensive considering that car doesn't have a carburetor.


How much should it cost to replace a blown head gasket on a Chrysler sebring V6?

The price to replace a blown head gasket on a Chrysler Sebring V6 should be around $1,000.00. The price can vary depending on where you have the repairs made or if you replace it yourself.


How do you replace the fuel pump in a 1999 Chrysler Sebring?

Drop the fuel tank


How do you repair a harmonic balancer for a 2001 Chrysler sebring?

You dont repair it...you have to replace it.


When should you replace the timing belt on a 2003 Chrysler Sebring?

100,000 miles


How do you replace a fuse on a 2001 chrysler sebring?

Pull out old, insert new.


How do you replace cabin air filter in 2004 Chrysler sebring?

It doesn't have one.


How much does it cost to replace the engine in a Chrysler Sebring?

The cost to replace the engine in your Chrysler Sebring will range between $2000 and $6000. Replacing with a used engine will be the cheapest and replacing with a brand-new engine will cost the most.