the push rods for the exhaust and intake on that cylinder are reversed. the exhaust pushrod is 6.07 inches whereas the intake is about 6.
They will have to be measured and cross referenced by the engine specifications. There is no other way to know what goes where.
the intake pushrods are shorter of the 2, all intake valves you can see with the intake off those pushrods go there, the rest are exhaust pushrods install in remaining holes
Is this for a 3.1 or 3100 V6? If so, the short push rods are for the intake valves.
yes it is, 3100 is in cc and the 3.1 is in letres
Yes.
You would need to call a parts house and they can answer that for you.
No
no difference 3.1 and 3100 are the same
I have a 1995 Skylark and the gasket was replaced about 4 years ago and I've had no trouble at all. It's a V-6 3100 engine.
no
123456
They are one and the same engine.