In the back of the cam shaft there is a slot that must be "level" with the head. Slide a flat stock of steel in the slot. Both valves must be closed on #1 cylinder. This can be determined when both the cam lobes are pointing up.
The purpose of the cylinder head is Luke Cooper
You can buy a new cylinder head for a 1981 VW Rabbit Diesel at most auto part stores. Salvage yards also carry the item.
diesel engine
A short block. A long block is a complete engine ready to install.
130
Either a single injector in the inlet manifold or, more normally, in the cylinder head(s), one per cylinder.
help
On the gasoline engines it is behind the passenger side cylinder head, through the bell housing. On the diesel engine, it is in the side of the block, behind the starter.On the gasoline engines it is behind the passenger side cylinder head, through the bell housing. On the diesel engine, it is in the side of the block, behind the starter.
i need the head torque settings for peugeot 1.9 diesel motor
there are 8 intake valves in that engine. They are located in the cylinder head, 2 per cylinder.
TUD5 engine head torques Stage 1. 40NM Stage 2. + 260 degrees Maximum head bolt length is 197mm.
engine block, it's function is to carry the engine or where the cylinder head set, piston, it;s function is to compressed the air and fuel.