No, none
what wires do i need to hook up to the alternator
the horn relay switch is in the fuse panel or it should be on the horn wires itself
Disconnect the battery negative. Loosen the belt and remove it from the alternator pulley. Disconnect all wires from the alternator. Unbolt the alternator from the bracket. Remove the alternator.
ANSWERWhat do you need to know about the coil ignition wires? we can't help unless we know what the problem is lol be just a little more specific
Remove serpentine belt, remove three bolts ,an 2 wires. The alternator will pull up off the motor to remove. Put new alternator in replace bolts, replace wires, an replace the serpentine belt..
I think the only way to get to it is to go inside the trunk. You will see the wires going up to it. Then after you losen it then you go back in side the car to change it.
I can help you I had that problem on my 1988 cutlass ciera and the answer is that one of the lights on the back not the third small on is not working. Open the trunk take out the bulb itself and check the wiring. That what was wrong with mine someone didn't have it wired right. Hope this helps you out.
This is a fairly simple replacement, behind the alternator will be your blower motor. There should be some small screws holding the case on to the ducting assembly, and a couple wires. Undo all, and carefully slide the motor out. DO NOT try to replace the motor, and use the old squirel cage. You will be making the repair again if you do. Just buy a new assembly with both the motor and cage.
how do you take the wires from the alternator on a 1997 Toyota Tercel
It is likely that you have a bad ground in the system... check all the ground wires
Number of Wires to an AlternatorThat depends on:the alternator,the wiring system in the vehicle
There are two options. It may be on the inside fender. It would be a square black metal box with at least four wires coming out of it. The other is it has an internal regulator in the alternator. If the plug on your alternator has two wires side by side coming out (II), it wil have an external regulator. If they are facing each other long ways (--) then it's internal.