just cut the rubber (glue) around that cover
do you mean theguide rail lock cover? if so... working at the rear edge of door remove two screws that secure it to the door and manipulate it out of the hole.
removel of door panal in ford fiesta 2002
How do you remove the dashboard on a 1996 Ford Fiesta
How do you remove the bottom front right airbag on a 2011 ford fiesta.
Remove the seat.
If there is not an access panel inside the vehicle above the fuel tank you will have to drop the fuel tank.
crowbar
To remove the air filter on the Fiesta MK6, first remove the bolts on the top of the air filter box. Then, pull upward to remove the rubber gasket around the box. Remove the screws at the rear of the box. Remove the filter and replace it.?æ
Drain the coolant from your Ford Fiesta radiator. Remove the radiator hoses. Remove the radiator stabilizing arm. Remove the radiator retaining bolts. Reverse the process to install your new radiator.
push tab in to remove
try accessing it from the inside of the trunk, if not that there should be some screws holding the fixture in place, undo those to remove it and the bulb will be right there
Yank it off
try a sledge hammer
To replace the front wheel bearing on a Ford Fiesta, you will need to remove the wheel. Then with a hammer you can pull the old bearing out.
by not mixing them REMOVE THE STIRRER
The most effective way to drain a fiesta is to remove the lower radiator hose at the radiator end
Buy A Cow And Some Sheep
Oh and it is cooking class right?
this website shows how to remove it 2003 model http://www.fitaudio.com/?View=entry&EntryID=69
You would remove the tank and pour it out of the fill hose.
You do not list the year. Unless you are talking about a Fiesta built in Europe that is fairly new, it does not have a Cabin Filter. The smell you are smelling is more than likely mold or mildew growing inside the vents. Very hard to remove. Search Google with the term "Odor from dash vents" for advice on how to remove it.
Open the bonnet. Remove the grill. Remove the screws holding the headlight in. Carefully pull the headlight out. Remove the cap on the rear of the headlight.
From the inside of the trunk..... You have to remove the inside to get to the bolts.... The there you go......
Remove the two rubber grommets on the inside and, with a flat-blade screwdriver, flick the spring steel catches inside, so that the light unit pops out of its seat, exposing the 18Watt wedge fitting bulb.
remove the tiny C clip from under the winder 1.25 1996 N. don't rip it off like I did.
Some bulbs can be changed by accessing them through the runk but I think your have got to remove the light assy and then remove the bulb.