answersLogoWhite

0


Best Answer

ARE YOU CLEANING THE SPOT WHERE THE MODULE SITS AND USING THE DIELECTRIC gel for heat transfer, also using cheap modules (china)will do it,make sure your coil and the carbon center/spring and insulator are installed correctly also insulate both side of rubber insulator under coil.make sure the ground clip is under coil or it overworks coil/and module make sure your plugs are gaped right. also check voltage at battery with car running rev it up make sure voltage is not overcharging. also check inside dist for oil if oil is present replace with rebuilt. give a small tug on the green and white wires that go to pick up coil if it breaks easy replace. other then that they should not burn that often back in the day it was common but should get a least 2 years go for a original a/c delco part that insulating gel is the lifeline of how long the part will last.it also wouldnt hurt to replace the stock 195degree thermostat to a 180 as i said heat is the killer of electronics and this car runs better at 180 than 195

User Avatar

Wiki User

โˆ™ 2012-03-18 04:19:09
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: On your '84 Corvette the ignition module keeps going bad is this common and what is causing this part to keep going bad?
Write your answer...
Submit
Related questions

Where is the ignition module 1984 Corvette?

The ignition module is located in the distributor under the rotor, it plugs in.


Where is the ignition module on a 1993 Chevy Corvette?

The ignition module on a 93 corvette is bolted to the ignition coil bracket, which is located on the top/ front of the engine, passenger side. Guy


Where is the ignition module located 1984 corvette?

The ignition module is located in the distributor under the rotor, it plugs in.


Where is the ignition module located on a 1987 corvette?

Inside the distributor.


Where is the ignition module on a 93 Corvette?

Remove distributor cap it is underneath.


What could cause a 1984 Corvette ignition module keep going bad is this common?

This is not common. Check to make sure there is not too much voltage at the dist.


What signals injector to pulse on a 1985 corvette?

The engine control by way of the ignition module.


Bad ignition module is also causing of not starting?

A bad ignition module will cause a no start situation in a vehicle because the needed spark is not created. It is responsible for telling the distributor when to fire.


Where is the ignition module located on a 1989 Mazda b2200?

where is the ignition module located on a 1988 Mazda b2200


Where is the ignition module 1999 Laredo?

The engine computer is the ignition module.


Where is the ignition module on a 1996 stratus?

The engine computer is the ignition module.


Where is the ignition module 97 explorer?

Where is the ignition module 97 explorer


What is a ignition control module?

the ignition control module is operated by the pcm,the pcm tells the ignition control module when to energize the coils to enable spark


How do i change the ignition module in a 1998 suburban?

Begin by removing the wiring harness from your 1998 Chevrolet Suburban ignition module. Remove the ignition module retaining screws. Reverse the process to install your new ignition module.


Where is the ignition module on a 1994 Dodge Ram?

Passenger side of the firewall, the engine computer is the ignition module.Passenger side of the firewall, the engine computer is the ignition module.


Where is the ignition module on a 1996 Eclipse?

The 1996 Mitsubishi Eclipse ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.


Where is the ignition module on a 1995 Honda civic DX?

the ignition module is located in the distributor


Where is the ignition module on a 88 tracer?

ignition control module is under the distributor cap


Location of ignition module 1998 chrysler?

The engine computer is also the ignition module.


Where is the ignition module located on a 1993 Hyundai Excel?

The 1993 Hyundai ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.


How do you replace ignition module in a 98' Malibu?

Remove the ignition module retaining ring. Pull the ignition barrel out. Remove the wiring harness from the back of the ignition barrel. Reverse the process to install the new ignition module.


Where is the ignition module for a Pontiac Grand Am gt at?

Not sure what the symptoms are, but I am guessing you are referring to the anti-theft module. It is located in the ignition cylinder lock. It is common for this to go bad in the Grand Am and other GM products. Not sure what the symptoms are, but I am guessing you are referring to the anti-theft module. It is located in the ignition cylinder lock. It is common for this to go bad in the Grand Am and other GM products.


How can you test the ignition modual?

ignition module on what?


Where is ignition module for 1993 Pontiac lemans se?

the ignition module is under the distibutor cap


Where is the ignition module on xg falcon?

ignition module is inside distributor along with hall sensor