Autozone.com has a lot of repair guide info for vehicles year 2000 and earlier. Here's where I found there info on oil pan repairs:
http://www.autozone.com/az/cds/en_us/0900823d/80/1d/f2/99/0900823d801df299/repairInfoPages.htm If that link doesn't work, just go to their main site (www.autozone.com) and follow the links under "Repair Info". Replacing the oil pan gasket on a 1994 Geo Tracker is a pain because you have to remove the front differential to be able to drop the oil pan. Since you have to do that, be sure and check other things that need to be fixed at the same time like CV boots or ball joints.
Replace the head gasket for sure. That is assuming you did not continue to drive the vehicle until you destroyed the engine internally.
YES! Replace the head gasket or destroy the engine if you continue to drive it.
You have to replace the gasket because when you take the manifold off it brakes the seel and air will be sucked into the manifold and your vehicle will hardly run, and you wont be able to drive it You have to replace the gasket because when you take the manifold off it brakes the seel and air will be sucked into the manifold and your vehicle will hardly run, and you wont be able to drive it
Pull the engine.
When it was damaged. If you don't have coolant leakage, but the level collant drops down it means you have internal leakage of coolant. You must replace the head gasket of course if want to drive your car. van over heats
More than likely you have a blown head gasket. Replace the gasket and check the head for cracks or if it is warped. Do not continue to drive.
Coolant in the oil, is a sign of blown head gasket or cracked head. This condition will destroy this engine if you continue to drive. Have this looked at by a professional. The repair is to replace the gasket, and possibly the head. Do not drive this car until this is repaired.
See the answer for "How do you replace the drive belt in a 2000 Ford Focus?". The procedure is the same.
I had the same problem with my 02. had to replace the EGR Valve.
(1995) ( Geo) ( tracker ),the wheel light comes on with the hubs locked in and the shifter in , but the 4 wheel drive does not appear to be locking in.
There are several things that can cause your 2003 Geo Tracker four-wheel-drive not to work. The first thing you should check is the ground wire on the switch.
You can drive it for as long as pie tastes good!
you can try My USB Tracker search on google
how do I get to the front bearing on a geo 4 wheel drive
The 1996 Geo tracker speedometer cable is held in place by a retaining nut at each end of the cable. Loosen the retaining nuts. Remove the speedometer cable guide retainers. Reverse the process to install the new speedometer cable.
No over drive. It only has a 3 speed automatic.
Remove fan clutch with fan impeller. Remove A/C compressor drive belt. Remove cap from tensioning roller. Relieve tension on drive belt. Remove drive belt. Reverse procedure for installation.
no you will blow the engine. get it fixed
Do I need any special tools to replace front wheel bearings on a Saturn 2002 L200?Also what is the procedure for doing so?
Only one way, remove the head and replace it. This is a major repair that should only be done by and expert.
You have to replace the whole drive shaft.
for a while. but once it's blown, it will gradually worsen until the car overheats too fast to drive or the motor locks up. it's best to replace it as soon as possible to prevent warpage of the head itself and/or the engine block.