answersLogoWhite

0


Best Answer

If it is a "hobby Grade" controlled vehicle, then the motor needs to be reversed, or there is a switch on the control to switch the motor. (I am assuming that when you put the vehilce in revrse it goes forward.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Radiocontrolled vehicle and when you control it to go forward it is stuck in reverse?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the definition of fully forward control in automobile chassis?

FORWARD-CONTROL VEHICLE - a motor vehicle in which the centre of the steering wheel is in the forward quarter of the vehicle's 'Total Length'


What causes a vehicle to move forward when in reverse?

Your gear linkage is offset!! Or you are on a steep down hill


What happens when you engage a reverse gear while in forward motion?

Bang depending on the vehicle, you will ruin the transmission.


Why would a 2003 Chevy impala roll backward in drive and forward in reverse when on inclines?

Weight of the vehicle


Why does your vehicle drive forward only?

does it shift into reverse and wont drive? if so its your tranny it needs to be replaced


What causes a squealing noise when driving forward but not in reverse?

It could be the transmission, it could be some parts under the vehicle that rub only when travelling forward.


What causes the vehicle to lunge forward or backward when the transmission is placed in drive or reverse?

Engine idle too high.


Why would reverse work in a manual trans and not forward?

Could be many things and depends very much on the vehicle.


Are the Reverse Lights on 94' Tarus linked to the Transmission?

The reverse lights on a 94' Ford Taurus are linked to the transmission to indicate when the vehicle is moving backwards. This is done for safety reasons as cars are typically moving forward.


What is the shift interlock system?

It is a safety system to prevent vehicles with automatic transmissions from being put into gear with out first depressing the break peddle. It prevent the vehicle from lurching forward or reverse when placing the vehicle into gear.


What is involved in a computer swap'97 S10 2.2l?

The process is pretty straight forward. With the vehicle battery disconnected remove the wires from the old computer and unbolt from its mount. Instillation is the reverse. Just make sure that the computers are from the same or compatible models or the engine will not control properly.


Is there a neutral switch on a 1991 Lincoln Continental?

Automatic transmissions have what is called a Neutral Safety switch. This eliminates the possibility of accidentally starting your vehicle in reverse or any forward gear. The vehicle will only start in park or neutral. Chris