Starter
Removal & Installation1. Disconnect the negative battery cable.
2. Raise and safely support the vehicle.
3. Remove the starter terminal cover.
4. Remove the terminal nut and separate the battery starter cable from the starter motor.
5. Disconnect the solenoid (S) terminal connector, if equipped with a starter mounted solenoid.
Ø To disconnect the hard-shell connector from the solenoid (S) terminal, grasp the plastic shell and pull off; do not pull on the wire. Pull straight off to prevent damage to the connector and (S) terminal.
6. Remove the starter motor retaining bolts.
7. Remove the starter motor from the vehicle.
To Install:
8. Place the starter motor in position and install the starter motor retaining bolts. Tighten the bolts to 15-20 ft. lbs. (20-27 Nm).
9. Install the battery starter cable and a terminal nut to the starter motor. Tighten the terminal nuts to 79 inch lbs. (9 Nm).
10. Connect the solenoid (S) terminal connector, if equipped with a starter mounted solenoid.
11. Install the starter solenoid safety cap. If equipped.
12. Lower the vehicle.
13. Connect the negative battery cable.
14. Start the engine several times to check starter motor operation.
How does one remove and replace the starter in the 1997 Bravada??
The starter relay is inside the starter. You will need to replace the starter.
Remove the positive cable from your 1997 Oldsmobile battery. Remove the starter cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
How do you replace starter in 1997 BMW 740il??
I replaced the starter on my 96' Avenger. It is located right beside the oil filter. To remove the starter I had to take off the oil filter and the part connecting the oil filter to the car.
You have to unscrew front right engine mount from bottom and lift engine (not remove).
How do you replace a starter in a 1997 F-350 Turbo Pickup?
Remove the positive battery cable from your 1997 Chevy Blazer battery. Remove the cables from the front of your starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
Where is the starter on a 1997 Honda Civic?
Go to the following website. It will show how to remove the door panel and the side mirror. kwmuth.com
It is on the passenger side on the engine above the transmission, down low.
try this.this is how it works on my 98 jgc. hope it helps Disconnect your battery, then remove the two nuts from the starter wire harness. Pull the wire and cable of the studs. Remove starter bolts and slide starter out of bellhosing.