The center console on a 1988 Honda Civic is mounted using several screws. Locate and remove all the mounting hardware to pull the center console off. After the screws are off gently pull the center console out.
center console, behind the cigarette lighter. u have to take out the screws to remove the panel and then its right there.
that would be under the center console
in front of the center console on the floor mat
None of the dashboard lights work on my 1988 Prelude. Why?
it clips on to the base by little "hooks" on the outer edges
Independent Civic Union was created in 1988.
To replace the heater blower cable on a 1988 Ford F-150, first remove the driver's seat. Then, remove console side panels, glove box, and radio. Pull of AC control knob and detach console from the?æfront frame at its corners. Next, remove console side braces, right vent distribution, steering column cover and left vent distribution. Finally, remove the 10 clips holding the heater blower cable and replace.?æ?æ?æ
Under the car dead center under console. Only way to access the pump and sending unit is to remove the tank. It is held by 2 straps and a bracket with 4 bolts. The tough part is getting the lines off.
pull ashtray.... remove rear screws behind tray.. pull tray forward to expose two screws in woodgrain center console...place transmission in low gear to allow room to remove screws. once removed slide console cover toward truck without lifting, as there is a plastic dowel holding the other end in place. lift console... slide switch out the top and remove switch. also remove pax window adjustment switch... slide both wires thru cutout and reinstall console cover. you do this first so you dont break plastic down..reconnect switches and then push them down into place... finish the rest in reverse order.
No it does not. I have an 88.
Yes. They are the same model
1988-1991 Honda civic dx,si,standard civic, crx dx,hf,si any Honda auto trans 1988-1991 will fit it
Lift up the rug /mat in the console. remove the screw holding it down. They pop out easily once the panel is lifted up.
I don't have a 1988 honda civic sedan. But if someone did, and that sedan had 14 inch wheels, then yes they would fit on them.
On the 1989 civic lx, the fuel filter is to the left of the fuel injector system. Follow the fuel line to a metallic enlarged looking pancaked shaped filter on the back wall of the engine compartment area, and that would be in front of the center of the dashboard area, as it were. I assume it's the same with an 88, so check there first.. what fram oil filter fits a 1988 Honda civic 1500 DX?
No it is not necessary to remove the axle nut in order to remove the front caliper. Once you remove the caliper the rotor should come off.
No, the 1986 design is structurally different from the 1988 design. They may look similar, but they are very different in size and shape.
Family Medical Center - 1988 Family Medical Center was released on: USA: 1989
Honda civic 1988 and later before 1988 they were on the side of the fuel tank 1988 on the fuel pump is in the fuel tank. 1.Detach the cable from the negative Battery terminal.Releieve the fuel pressure from the system (Slitly on srew the Service bolt on fuel filter) 2. Remove the rear seat 3. unplug the electrical connectors from the fuel pump and sender unit. 4. Remove the fuel tank from the vehicle 5. remove the mounting nuts from the fuel tank, 6. remove the fuel pump from the tank. 7. Remove the sock filter from the end of the fuel filter. 8. Detach the pump from its brackets 9. installatin in reverse of removal.
Might have slight differences. They are both in the 4th gen or EF class of civic. 88-91.
Family Medical Center - 1988 Valium Addiction was released on: USA: 1988
first remove the belt by inserting a 3/8" drive in the square hole on the tensiner, then remove the one bolt just below the tensioner and then remove the center bolt on the pully (allen wrench).
Yes u can