The coil springs are not easy to remove or install. The spring needs to be compressed in order to be removed. It takes several hundred pounds of pressure to compress the spring.
on the thermostat housing at the top of the engine block, normally secured by a spring "c" clip.
You can replace the spring with proper tools. Be VERY CAREFUL a spring that is not caged can inflict serious injury.
To replace a broken garage door spring, you first need to determine the type of spring used; either torsion or side-mounted. To determine the type of spring, and then to replace the spring, there is a very good website that has all of the information available to replace and adjust the door springs. The website is at http://www.naturalhandyman.com/iip/infgar/infgar1b.html.
remove drivers side front wheel, plastic panel behind spring/shock. real fiddly but can be done with minimal swearing ! if you have A/c then the air may be a tad bluer!
If the cord hangs loose/does not rewind you have a broken rewind spring. Not difficult to replace.
What do you mean by a stuck shifter? If it doesn't return then the spring is broken, You have to pull the tranny out to replace it. You either have a broken spring or a bent fork or a bent shaft. You need to open it up to see whats wrong
I would as it increases your stopping distance - I also have this problem on the front since rear impact on my jeep.
no
A weak spring or broken valve seat. Just drain tank slightly and replace it,they are cheap and not worth fixing.
Pull steering wheel, remove steering plate to access turn signal switch. There are two swings as you look down at switch that should be broken. Your Cam spring is broken. best to replace turn signal switch
could be glow plug indicator if its a deisel
Yes. It could be partially broken.