The fuel is cut off to the engine. With no fuel it stops running immediately.
When the engine 4jg2 starts then its stops it is due to a mechanical failure.
out of gas or engine has problems; advice: consult manufacturer
the system will do run for some time in knocking state and missfiress and then stops finaly...... sanaan +919997931042
How can i take off the alarm on my 1999 oldsmobile intrigue?
This jerk your referring to is probably just the pistons coming to a halt. Diesel engines have very high compression, thus the pistons and sometimes blast downwards when the engine is shut off.There is nothing to be done if thats the case. If it has a clutch, your probably letting the clutch out before the engine completely stops.
well if its a 7.3 litre all you do is loosen the return line off your fuel filter which is right on top the engine. its on the driver side have your buddy crank it for 20-30 seconds and loosen it after he starts cranking and tighten before he stops. if you dont it will bleed off. of course you want to make sure you put fuel in it.
Yes, a switch is a device that stops and starts current flow in a circuit.
Your probably spotting
If it starts and stops within seconds and after a few minutes starts again only to stop again, the fuel filter is probably clogged,
Dieseling Engine overheating? Engine idling too high? Try a higher octane fuel?
It could be a very dirty fuel filter, replace it first before you spend any more money on parts.
Why engine stalls on 1993 Chrysler Intrepid while driving and sometimes at stops?
It starts when diplomacy stops.
is this automatic or standard? Check fuelline if has air or too much water inside fuelline. Try using some fuel injection cleaner and gas treatment masde for diseal gas.
The stratosphere stops and the mesosphere starts at about 31 miles (50km). The mesosphere stops and the thermosphere starts at 50 - 56 miles (80 - 90 km).
Motion which starts and stops regularly.
Most auto part stores can scan and determine problem
Remove the carburator.. and there should be a screw in the bottom of the cup..remove the screw and clean out the cup... make sure to be carefull with the floater..it make come out...
a point at each side