0
The crankshaft is the part of the ignition system that watches engine speed. To remove the sensor, pull the battery cable with slip joint pliers, lift the front of the car with a floor jack and chock the back tires, find the crankshaft sensor and unplug the electrical connector, clean around the area and unscrew the sensor mounting bolt. To install, make sure the new sensor has an O-ring seal and set the sensor in place, start the bolt by hand and finish tightening with a wrench (careful not to over tighten), plug the electrical connector and install any parts you had to remove. Lower the vehicle and remove the chocks.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
Where is the crankshaft position sensor on a 1997 Chrysler town and country?
It is on the top rear of the bell housing.
Where is the crankshaft position sensor on a 2000 Chrysler Town and Country?
on the left top side of engine behind the thermostat hosing.
Where is the crankshaft position sensor located on a 2003 Chrysler Town and Country 3.3?
It is on the top rear of the transmission bell housing.
Where is the crank sensor on a 2002 Chrysler town and country?
The crankshaft position sensor is on the top rear of the transmission bell housing.
Position of crankshaft positioning sensor on 1996 Chrysler 3.8 town country?
Top rear of the transmission bell housing.
Where is the crankshaft sensor on a 2000 Chrysler Town and Country?
It is on the top rear of the transmission bell housing.
How do you fix starter on a 1998 Chrysler Town and country?
Replace it.
Where to find a diragram to replace a water pump on a 2006 Chrysler Town and Country?
where can I find a diragrame that shows how to replace a water pump on a 2006 Chrysler town country tour van
Where is the crank sensor on a 2000 Chrysler Town and Country?
The crankshaft sensor is mounted to the top rear of the transmission bell housing.
Where is the crankshaft sensor on a 2005 Chrysler Town and Country?
The crank sensor is mounted on the top rear of the transmission bell housing.
Im working on a 97 Chrysler town and country 3.8 liter dealing with a no start it cranks has fuel no injector pulse and no spark replaced ignition coil and crankshaft position sensor doesnt start?
Have the system checked for trouble codes.
Do you have to pull engine on 2002 Chrysler town and country to replace timing chain?
No.
