how do i replace the hub assembly on a 1997 cavalier 2.3 Ls
part of the hub assembly
The wheel bearings are not really replaceable by themselves. This is because they are integrated into the hub assembly. So the answer is that you will have to replace the entire hub assembly to replace the bearings.
With a Hammer
It's easy, you have to replace the entire hub!When the bearings go bad, you have to replace the whole hub! Simple! It's easy, you have to replace the entire hub!When the bearings go bad, you have to replace the whole hub! Simple!
Remove tire, remove brake drum, remove brake assembly housing, remove 4 bolts from back of hub assembly, gently tap to remove hub/bearing assembly.
Front or rear?
The front bearing for a Dodge Stratus is attached to the Hub. To replace it remove all the components on the hub assembly. There are three bolts that hold the assembly in place. Loosen the bolts and pry out the hub. Replace the unit.
Both the front and rear bearings on a 1998 Cavalier are contained in the hub assembly. The rear hub is attached with four bolts, and the front with three.
the same way you would replace any hub assembly, take the wheel off, take off any bolts that connect the hub to the driveshaft and then replace it
the wheel speed sensor is all part of the wheel bearing hub assembly you cannot clean them you have to replace the hub assembly its not that hard of a job gm cars are known for this problem.
Front is easy, just replace hub rear is pressed in
You can replace both... Bearing or Hub... Bearings are cheaper, but harder to find and replace. Hub assemblies are easier to replace, but slightly more expensive.