remove rear drive shaft. remove pinion yolk from front of diff.remove oinion seal replace with new one. replace pinion yolk, replace driveshaft,.. dhceck ujoints of drive shaft while out, its a good time to replace them
to replace pinion bearing and seal you need to remove drive shaft.you then remove the pinion nut from pinion shaft. u usually need a pretty good rattle gun to remove this .then remove yoke from front of differential.u may need a puller but usuall tapping with hammer will loosen it. remove the bearing and replace with new one then install seal and replace cover and ypke. replace pinion nut, fill with oil.replace drive shaft
Old out, new in
Some of those setups have a crush sleeve that must be replaced along with that seal. It also requires specific torque specs To replace seal, remove the drive shaft, remove the pinion nut and crush sleeve if required, remove seal, install new seal and crush sleeve install pinion nut and torque to specs
to replace pinion shaft seal you need to drop the drive shaft from the rear end then with large socket remove pinion nut from front of yoke remove yoke remove old pinion seal install new pinion seal reinstall yoke and pinion nut to specified torque re install drive shaft note now is the time to check and see if U-joints need replacing
to replace pinion shaft seal you need to drop the drive shaft from the rear end then with large socket remove pinion nut from front of yoke remove yoke remove old pinion seal install new pinion seal reinstall yoke and pinion nut to specified torque re install drive shaft note now is the time to check and see if U-joints need replacing
210ft. lbs.
Best left to a mechanic as the drive shaft has to come down and the big nut on the pinion gear that holds the drive shaft mount has to come off and then you can install the new pinion seal.
The pinion seal is shot. A mechanic can replace the seal and check for problems.
Remove driveshaft,remove pinion nut that holds the driveshaft yoke on. Then remove the yoke and the seal will be behind the yoke.To pull the seal you need a seal puller or you could use a couple of screwdrivers to pry it out of the axle housing. Install seal & asm in reverse order.
how to cahange front pinion seal
No. The pinion seal would be at the differential input.