Car Starting Problems
Chevy S-10
Windows XP

Replaced a crank angle sensor in a vn drove like normal then i got back in the car 3 hours later and wouldn't start. might start later though and run normal and stop again what could be wrong?

User Avatar
Wiki User
2006-12-18 08:38:25

Check the sensor again. Pull the sensor and check the face and

make sure there is no foreign matter stuck to it. Check the

postition it is in before removing it. If it's clean then insert it

a little bit further into the openning but be careful not to go too

far. Since most crank and cam position sensors are inductive any

foreign matter on the active area will cause false signals.

Metallic shavings in your oil will play havoc on these sensors.

Hope this helps.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.