answersLogoWhite

0


Best Answer

Make sure you have voltage at the pump. If you do then the new pump is defective. If not, the fuse is blown or the fuel pump relay is bad.

Where is relay?

User Avatar

Wiki User

13y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

16y ago

have you checked the fuel pump relay

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: New fuel pump wont work
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

1997 Pontiac transport Why wont your fuel pump work New fuel pump relay and power to the pump but it still does not work?

Bad fuel pump?


What to do if you installed new fuel pump relay and fuel filter no fuel to the engine wont start?

Does the fuel pump work? Check that. yes.


Why wont your new fuel pump work?

The pump could be defective. Or the power may not be getting to the pump. Check the pump fuse and relay to start with.


Why wont you get fuel when the pump is running?

Either the fuel filter is clogged or the fuel pump is defective, even if it is a new pump.


Can you put a carburetor on a 4.3 vortec?

yes you can just change intake but then you have to figure out a new way to get fuel to it stock pump wont work


Would the car needing a new fuel pump cause the car to not run?

yes if you need new fuel pump, the engine is not getting fuel. therefore no fuel equals engine wont run


Why wont new fuel pump pump?

There are a few possibilities. First off that new fuel pump might be defective. You would not be the first one to buy a defective brand-new part. Secondly the fuel pump fuse or fuel pump relay may be defective. And thirdly that fuel filter may be clogged.


Why wont your car start after replacing the fuel pump on a 1999 ford escort 2.0?

Check that the 'new' fuel pump is actually pumping.


Your 2.8 v6 wont start after new fuel pump installed what could it be?

Do you have power at the fuel pump relay test connection. do you have fuel at the schrader valve on the fuel rail.


Why wont the engine start even with a new fuel pump pump works but no pressure sometimes it will run and some time it wont engine is a 3900 1996 olds?

Did you change the fuel filter? Have you checked the fuel pressure regulator?


Bleeeding the fuel lines for the fuel pump?

It is unnecessary to bleed the lines after installing a new fuel pump. The fuel pump will pump all the air out of the fuel lines and start to work properly without any bleeding. Just install a new fuel pump and start the engine.


How do you know if your fuel pump is bad or if you need a new fuel filter for a 1988 jeep wrangler?

if you're fuel pump is bad it will most likely die and wont start or wont run very long, or it will run but will seem like its out of gas, replace the filter first its a lot cheaper then the pump, if its not that then its the pump