answersLogoWhite

0


Best Answer

Your original key is micro chipped and coded, your new key most likely has no chip in it. Car won't start unless the micro chip in the key and the car are programmed to match.

User Avatar

Wiki User

โˆ™ 2008-11-24 00:16:31
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: Replaced ignition switch from a 2000 Ford Focus every thing turns on except engine?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why does your engine still run when you take the key out of the ignition?

check the ignition switch , it might be bad and may need to be replaced.


Why does your car stop running when the key is released?

If the engine stops running when the key is released, then the ignition switch is probably bad. The switch will need to be replaced.


What causes ignition switch to not turn an engine over?

A bad connection inside the ignition switch will keep it from turning the engine over.


Is there a kill switch on a 1998 dodge neon sport?

No, there is no kill switch except for the ignition switch.


99 Concord engine won't turn off have to pull fuse under the hood replaced ignition switch already now what Can turn key to off position and radio ac etc turns off but not the engine?

sounds like you have a broken ignition wire between ignition switch and fuse box


Can the ignition switch cause your engine not to fire?

Yes, sometimes a faulty ignition switch can cause the engine to not fire. Also, a bad spark park can the engine to not fire.


How do you remove the ignition switch of a 97 Suburban?

you can take it to be replaced it has a recall on them


I have a 1997 Ford Aspire that I replaced the ignition switch. I now dont have any fire to the ignition. Is there a problem with the ignition module or the ECM?

are all the connection plug in on the switch and did you have fire before replaceing switch


How do you change the ignition switch on a 2002 Hyundia Accent?

To changeÊthe ignition switch on a Hyundai Accent, first, one should remove the switch from the steering column, to which it is attached. From there, the component can be replaced.


1991 Honda Accord LX Replaced the battery alternator and main relay Turn the ignition switch the power comes on however try to crank the engine the power goes dead The power then re setts fuses good?

engine seized, starter not working, ignition switch,chek fuses ALL!


What could cause a no voltage at the plug primary sidefeeding the coil I have replaced the starter relay Engine turns over Ignition switch was replaced last month shut off and would not restart?

What type of vehicle is this?


Why won't my ignition switch turn on or off in a1991 Chrysler New Yorker?

It sounds like your ignition switch will need replaced. The one that is inside your steering column.

People also asked