Cars & Vehicles
Replacing a starter on a 2001 olds shilloutte should go through tire well or from under car to get to starter?
Asked in Chevy Suburban
How much should replacing the starter in a 1999 Chevrolet Suburban cost?
What should you check next on a vehicle that will not start after replacing the fuel pump and wires and fuses?
Asked in Chevy Camaro
Starter grinds on 1988 Chevy camaro when starting is this a faulty starter?
Asked in Chevy Lumina, Chevy Silverado, Chevy S-10
How much should replacing a starter on a Chevy S-10 cost?
Asked in Clutches and Flywheels, Chevy S-10, Chevy 350
If your starter whines loud while at idle Is it the starter that needs replacing or it is the flywheel?
Asked in Mitsubishi Galant
Cost of replacing a starter in a 2002 Mitsubishi Galant?
How much will it cost for a Ford KA starter motor?
Asked in Car Batteries, Pontiac Bonneville
What would cause a 2000 Pontiac Bonneville not to have power after replacing the starter and reconnecting the battery?
Asked in Car Starting Problems, Kia Sephia
Engine turns over but car wont start when cold when warn car starts 1996 Kia Sephia 1.8 automatic?
If your car works fine when its not cold and only wont start when its cold outside then its a bad solenoid and most likely the one that regulates voltage to your starter. This solenoid can not be replaced with out replacing the starter because they are combined. Unless you have a aftermarket starter that will let replace the solenoid without replacing the starter. So all you have to do is take it to a shop and have a new starter put in and your prob should be fixed.
How do you know when a starter is bad for a 1998 Ford Taurus?
Starter c-180 compressor?
Why won't my radio work after replacing my car starter?
Asked in Dodge Dynasty
How do you replace a starter on a 1986 dynasty?
First, there is no such thing as an 86 dynasty, the first model year was 88. As far as replacing the starter, you will have the easiest access from underneath the car. Remove all wires and bolts connecting the starter to the car, and remove it. If you are buying a brand new starter it should come with shims to help possition the starter for proper gear mesh ( you will have to adjust accordingly ) other than that just install the starter the same way you took It out, just backwards.
What do you do if a few days after replacing the starter the engine wouldn't turn off and your replaced ignition switch and solenoid but it is still doing it?
be sure to double and triple check the wiring of the starter. If for some reason the two posts coming off the starter are grounded the flow of electricity will keep moving keeping the motor running. the positive battery cable should go stright to the starter to the positive post(usually the one on the top when you look down at it from top of motor), then the ground should actually be somewhere on the transmission(usually the post on the bottom looking down) then there is usually a third connection point(no post) that goes to the solenoid, if not go through the solenoid then to the starter with the positive wire. good luck
Asked in Ford Bronco
Are there two negative connections on a 1990 Bronco starter?
There shouldn't be. The negative battery cable should ground to the block or the frams. There are three connections on the starter if the solenoid is on the starter as it is on a Sable. The biggest connection is for the positive battery cable. The one directly underneath it is where the braided cable coming out of the starter is connected, and the spade connector is where the ignition switch wire slides on. The starter itself usually grounds by being mounted in place through the starter bolts. but some ground internally through the brushes. .
Asked in GMC Sierra
How do you change starter on a 1996 gmc sierra?
the starter should be on the right side of the engine block there aretwo or three bolts going into the block then the starter should come down a little but on the front of the starter there is a nut holding on wires to the starter i think they are 10mm. once the bolts are out of the block and no wires are on the front of the starter it should come out. its a 10 minute job if that
Asked in Sony Playstation 3, Playstation 3 Move
Should you buy the playstation eye or the starter pack?
Asked in Car Starting Problems
Why will my truck not start with the key after replacing the battery and the altranater but will start when jumped at the Solenoids?
well depanding on ther truck if you have a ford with a starter solenoid on the pass firewall when you try to start it with the key it should make a click sound if not you have a bad starter solenoid if a Chevy and your jumping it from the starter it self you have a bad solenoids i would replace it Chevy you can some times buy the solenoid it self but i would buy a new starter just in case
Asked in GMC Jimmy, GMC Sierra
How do you remove a starter from a 1995 GMC Jimmy?
If this is a 4X4, this can be a little tricky, you can access the wiring to starter through the wheel well, this starter is probably expensive, as it is smaller than the average bear. Good luck. HTH You first need to look under your passenger wheel well and remove the nut that connects your wire to the starter (also there is another wire with a smaller nut to disconnect from the starter). Next remove the cover plate that�s directly below the front of the starter, there should be six bolts to remove. Then remove the two bolts out of the starter, after the starter is loose. You then should be able to angle the back of the starter up towards the wheel-well. Now you should have enough room to take the smaller wire off of the back of the starter. After that�s off you�re able to remove the whole starter from your car.
How do you replace the starter on a 2000 Nissan Maxima SE?
Actually, this answer was completely wrong. The starter is on the drivers side, under the air cleaner. You should remove the air filter and its plastic housing and you can see the starter bolted to the engine. There is a very good step by step, with photos, at www.cardomain.com/ride/2076435. Steps for replacing the starter: (1) disconnect the negative and positive cable from the battery and remove it from the car; and then follow the directions in the site I listed. Good luck!
Infinite Starter location infinite starter placement Where is the starter on my infinite G20?
Asked in 1995-2005 Chevy Cavaliers
Starter makes grinding noise after engine is warm but if the remote start is used there is no noise is this due to a relay through the ignition switch?
Asked in Ford F-350
How do you change starter on 97 Ford F350 diesel?
to change starter, first disconect battery there are 3 bolts that hold satarter to bell housing thses bolts are easiest removed using a socket on a socket extension you will need to remove wires from front of starter before removing starter. be sure to make sure replacement starter has the same nuber of teeth on gear or starter will not mesh with ring gear. note if you have a spacer between bell housing and starter when removing old starter. this spacer if there is one, needs to be reinstalled with new starter. after removal of the bolts the starter can be pilled from bell housing and new one installed when replacing bolts in starter , tighten evenly or the started will be installed crooked and will wear out gears re attach wires at starter reconnect battery cbles should be good to go