0
0 is highest, 15 is lowest.
The highest-priority ID on the SCSI bus is 7. You normally assign this ID to the host adapter. Next in priority, from highest to lowest, are IDs 6-0 and then 15-8. So 0 has higher priority than 15.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Which ID number is normally assigned to the SCSI controller?
The ID number which is traditionally assigned to the SCSI controller is ID 7. ID 7 is given the highest priority during bus arbitration.
What scsi id should be assigned to a scsi-2 adapter card in a computer?
The host adapter is assigned SCSI ID 7, which has the highest priority over all other devices.
SCSI bus can support up to how many devices simultaneously?
SCSI, Fast SCSI, Ultra SCSI, Ultra2 SCSI: 8 devices Wide SCSI, Fast Wide SCSI, Ultra Wide SCSI, Wide Ultra2 SCSI, Ultra3 SCSI, Ultra160 and 160+ and Ultra320 : 16 devices Of course, the number of devices supported depends not only on protocol limitations, but cable length, number of cables used, etc.
What is a SCSI ID number?
SCSI - Small Computer System InterfaceSCSI is an industry standard system interface, which allows multiple peripheral devices to be installed on the system. The number of devices that can be installed depends on the type of SCSI Host adapter that you have installed in your system. Most SCSI systems have an older "Narrow" 8-bit SCSI host adapter, which have 8-bit data paths and allow for up to 7 devices to be installed on the same channel. Newer "Wide" Host adapters have 16-bit wide data paths and provide support for up to 15 devices. A SCSI ID is a unique identifier assigned to each SCSI device on the bus. It determines the SCSI device's priority. There are 16 IDs, ranging from 0 to 15. The order of the priorities is a bit unusual. From highest priority to lowest they are: 7, 6, 5, 4, 3, 2, 1, 0, 15, 14, 13, 12 ,11, 10, 9, 8. ID 7 is almost always reserved for the SCSI Host Adapter. The other IDs are free to be assigned as desired, although your computer may have assigned them automatically.Never assign the same ID to more than one device.
How is the priority sequence established in a wide SCSI environment?
its' very strange actually...i am also wondering...are you taught by nagure?
What is a task that you have to perform when installing SCSI devices?
Assign each SCSI device a unique ID number
What is an accurate number of SCSI devices that can be connected on a SCSI bus including the host adapter?
8 devices:)
Which jumper setting cannot be found on the back of an IDE CD-ROM drive?
SCSI Channel
Which scsi hard disk has highest priority?
7 would be highest prority, then 6,5,4,3,2,1,0. For wide scsi, it is still 7, then 6,5,4,3,2,1,0,15,14,13,12,11,10,9,8. Scsi controller should be set to 7, and for hard drive, 0 CD-ROM=3 This is the standard, though as long as each device has a unique I.D. all should be well.
What is SCSI ID number for CD?
id 2
Which version of scsi is known as fast scsi?
SCSI-2
Which two SCSI connectors might be used with narrow SCSI?
DB25 SCSI connector50 pin SCSI connector
