If the tractor had a battery in it when you were jumping it, there is a chance that the battery is bad. Try unhooking the tractors battery and trying again. Hook your jumper cables to the battery cables themselves without being attached to the battery. If it runs then just replace the battery. A battery with a short in it will keep the mower from charging and could cause it to die.
If there was no battery in the tractor when you were jumping it, then the tractor is not charging and will have to be diagnosed as to what the problem is.
You can reset the computer in your H2 Hummer by disconnecting the ground cable from the battery. Leaves the battery cable disconnected for 10 seconds, and reconnect.
Hook a battery to it and let it spin for a few seconds.
Hook a battery to it and let it spin for a few seconds.
on my 2000 I disconnect the positive battery cable and press down the brake pedal for 30 seconds and that will reset it
Try disconnecting one of the battery posts, wait a few seconds and reconnect it. This resets the unit and it should let you eject the discs.
Try disconnecting battery for 10 seconds this has worked for me in the past when i had a air bag fault steve
most of the time the indicator lights can be reset by disconnecting the positive battery terminal for 10-20 seconds before reconnecting it.
You will need to raise the drivers side window all the way up and then hold the button in the up position for about 20 seconds, that should do it.
try disconnecting your negative battery post for 15 seconds to reset the vehicles computer, if this does not work ,adjust cable to the fuel injectors
The engine computer on a 98 Holden Vectra is reset by disconnecting the battery for 30 seconds. This allows the computer to power cycle much like a home PC.
The check engine light on a 1999 Cadillac DeVille can be reset by disconnecting the battery for 30 seconds. The light will immediately come back on if the problem still exists.
Unplug the control unit by removing the fuses, or disconnecting the battery. After waiting a few seconds, reconnect the unit. Then turn the key to on. Wait 5 seconds, then press and hold program on the remote for 5 seconds. The door locks should cycle once. It only programs on the first key on after a power off reset, so if it doesn't work, you need to disconnect the battery and try again.