After finding top dead center by turning engine over till compression on #1 cylinder and setting distibutor with rotor at #1 cylinder . engine was ready to be turned over . engine started now at this point is it necessary to remove a wire for crank sensor or ignition system to set the timing w a light.
That requires an OBD2 engine scanner to set the timing. You can NO longer use a timing light.
That requires an OBDII engine scanner to set the timing on that year. A timing light is no longer used, It's a thing of the pass. It is all computer controlled now.
That requires an engine scanner to set the timing.
timing was set at factory,there is no adjustment. it is controlled by ecm!!
There is no timing ajustment, Its controled by ECM- Computer.
You need a timing light to set the correct timing. Once the truck has been set at base timing at 0-2 degrees by disconnecting the timing wire and setting the dist., the computer adjusts the timing by itself to the proper setting.. There is not an adjustment for the the idle speed on this truck.
The timing on that year engine is computer controlled. It requires an engine scanner to set the timing. YOU CAN NOT USE A TIMING LIGHT.
How do you set the timing on a 2000 Chevy blazer (V6)
This is set electronically by the computer...nothing to set.Answerthe only wayto look at the timing is to set up a timing light and look at the crankshaft pully. but there is no way to set it on this truck
Need to know the year, and what it's in they are all different.
There is no way to tell you, because the timing is controled by the computor. You can not use a timing light. It requires an OBD2 engine scanner to set the timing to specs.
how do i set the timing on a 1998 cadillac deville 4.6