Chevy Silverado
Jeep Wrangler
Toyota 4Runner

Should the drivers seat on a 1991 YJ be loose?

222324

Top Answer
User Avatar
Wiki User
2005-11-25 21:22:30
2005-11-25 21:22:30

I have a 1992 YJ, and the seat is not loose. I don't think it would be safe to have a loose seat.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

No, I have a 90 YJ and it's a solid frame molded seat. Check the under side of the seat where the slides bolt up and make sure the frame is ok.

User Avatar

should be by your left knee while in the drivers seat--under the dash:)

User Avatar

by your left foot when sitting in the drivers seat

User Avatar

Should be under the drivers seat

User Avatar

It is a loose connection under the drivers seat toward the back. Disconnect and reconnect that should solve the problem

User Avatar

Under the drivers seat. Open the door an you should see the fusebox cover below the drivers seat at the right hand side.

User Avatar

remove the bench seat behind the drivers seat. remove the service panel from the interior panel on the drivers side.

User Avatar

there should be a plug in under your drivers seat drive safe

User Avatar

Lift up on the front of the back seat and it should come loose, then up and out.

User Avatar

there should be 4 bolts that hold the seat to the floor. just remove them and if it has power seat dont forget to unplug them.

User Avatar

it is under the drivers seat, yellow lever to pop the seat back, under the panel. same area as the oil fill.

User Avatar

by the battery and theres a fuse panel by ur left foot when ur in the drivers seat

User Avatar

look under the drivers seat and passenger seat and there should be a wire coming off the seat belt that you can unplug to stop the chime.

User Avatar

Should be right behind the drivers seat in the storage compartment.

User Avatar

Should be along the frame under drivers seat.

User Avatar

i own a 87 suzuki savage i would expect it is the same steps there is two screws that hold the seat on there located towards the rear of the drivers seat not the passengers seat after removeing the two screws the seat should lift free there is one screw under the drivers seat that holdes the passenger seat on remove that and push the passenger seat forward and lift

User Avatar

the rear seat is held in by one bolt which you can access through the hatch- that's it! once that bolt is removed, the two clips on the front bottom of the seat can be wiggled loose, and the seat is out.

User Avatar

Order a new seat locking lever from FORD, it should be accessable from the drivers side where you adjust the seat.

User Avatar

THere should be an "L" shaped bar under the seat that is touching the floor. I find it is very hard to lift sometimes and have wacked my hands a few times. When it does come up just wiggle the seat back and forther until it is really loose. then left it out.

User Avatar

There is a plug under the drivers seat that has come loose reach under and tap it or squeeze it together.

User Avatar

when setting in the vehicle in the drivers seat it is directly bedide the seat on the right side of the drivers seat in the floor!


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.