why wont the blades/auger on my JOHN DEERe snow blower turn?
first thing i would check is to make sure there isn't a piece of wood or something jammed between the blades and housing. i don't know if your blower is shaft or belt driven. if belt driven check the belt and pulleys. if it is shaft driven try to spin the blades by hand, if they turn free then the shear pin is broke. look for a small round steel pin in the same are the blower shaft attaches. it should go through the shaft all the way from side to side.
If all the parts are moving and look like they are working right the problem could be that the snow is too wet. Many blowers won't throw snow that has started to melt. It just clogs up the chute.
turn it on
Instant snow can't melt.You can play with it any time you want.It also wont hurt you at all.It is also not affective to no ones skin.
Assuming your dryer blower does run, then you must have one of the phases dropping out. Check all electrical connections at the breaker or fuse box, dryer receptacle, and wiring going into the dryer. If your blower runs, then your neutral is probably okay. Check one of the "hot" leads. I suspect one has come loose, or wasn't fastened at all.
yes it will turn on. but you neet to put good pin ;]
If yours is self propelled and has a drive clutch you can let off of the drive power. What is happening is your snowblower is trying to eat more snow than it can in a reasonable amount of time. If you are not under an excessive load, its usually a blockage in the carb or old fuel. try new gas from the gas station, replace your spark plug, if this doesn't work you may need to clean the carb.
Common causes, blower motor resistor, blower motor, wiring or controls
Got a toro 521 wont blow snow after 2 feet whats up
The blower on a 2002 Nissan Pathfinder won't turn off if the switch is stuck in the on position or the relay is defective. Removing the blower fuse will cause the fan to turn off.
well in the winter they turn white to blend in the snow so it wont get eaten.
I have a 1978 coupdiville cadillac my blower quit working and there is a relay above your fuse box and if it goes bad your heater wont turn on. I had to replace it with a after market heavy duty relay away from where it is originally plugged in. Also my ground wire connection was dirty and wouldn't turn on until I cleaned the connection so try that and see if it works or you might need to replace the motor.Fleetwood_brougham_BLOWER_wont_turn_onDiscuss:Fleetwood_brougham_BLOWER_wont_turn_onFleetwood_brougham_BLOWER_wont_turn_onbrougham BLOWER wont turn on?&content=&lng=en&uid=X4b8f331cb1dc6e1a Fleetwood_brougham_BLOWER_wont_turn_onbrougham BLOWER wont turn on?&content=&template={{title}} {{url}} (via @WikiAnswers)&lng=en&uid=X4b8f331cb1dc6e1a
Your friction plates might be warn,bad bushings, linkage could be needing adjustment and that also depends on make and model it is.
== ==
If the cooling fans will not turn on, check the pump to make sure the belt is turning the pump. Also check the blower resistor. This large fuse is usually located on the fuse box for the battery on most vehicles. On older vehicles it might be located on the blower motor itself.
Check the blower motor to make sure its working propable
AnswerIt is an Electric Blower, And it senses that the vehicle is still very warm, so it keeps running to cool the engine -Mr. Mechanic-Could also be the blower motor resistor if it wont turn off at all
Could be, a bad blower motor, a blown fuse, a bad resistor, a bad switch, damaged wiring,
Blower motor bad. Blower resistor bad. Switch bad. Fuse blown.