is there a "special tool" to put torsion keys on a ranger
The Torsion bar is a suspension component. It essentially "twists" ever so slightly to adjust ride height. This is adjusted by a special tool specific to the manufacturer.
No. The torsion bar tool has a pin in it that goes into the dimple on the torsion key to locate the tool. Thus keep the tool in place, so your fingers don't get cut off.
The special tool is available at most auto supply stores (AutZone, etc.).
the torsion bar is actually a rod which is twisted when load is applied on opposite direction like couple
You need a special tool that is sold at most auto parts stores.
I had the same problem with my 98 ranger you need a a special tool to remove the brackets that hold it in place It is not an easy task
pulley tensioner replacement%ford ranger xlt 3.2l 2wd instructions. do use an ALLEN wrench to loosen the spring or is it a special tool
You need a special tool for the job. The tool is available at most auto parts stores.
You need a special tool available at most auto parts stores (AutoZone, O'Reilley's, etc)
t64k-44890-b
5.5 mm but takes a special tool to remove module the tool is 4.99 at auto zone just tell them what ur replacing and they will get you the o.e.m ignition module tool
You need a special tool available at most auto parts stores (AutoZone, O'Reilley's, etc)