0
There are two types of cable used for television radio frequency signals: 300 ohm twin lead flat cable and 75 ohm coaxial cable. The twin lead is typically used with a rabbit ears antenna and coaxial is typically used with roof top antenna or cable TV setups.
For television baseband video signals coaxial cables are usually used.
However for digital television baseband video signals these are not adequate and special cables (e.g. HDMI, DVI, DisplayPort) are used. These cables are typically many twisted pairs in a common shield.
Coaxial cable
Wiki User
∙ 8y ago
Wiki User
∙ 12y agoCoaxial? 75Ohm Type "F" Connector RG54
Wiki User
∙ 14y ago`Coax' or `coaxial cable'.
Wiki User
∙ 8y agoYou may be thinking of a co-axial cable.
Wiki User
∙ 14y agoCoaxial :)
Wiki User
∙ 13y agocoaxial
Add your answer:
Earn +20 pts
What is the technical term for a kind of cable that carries a TV signal?
coaxial
What the technical term for the kind of cables that carries a TV signal?
Coaxial
What kind of television signal is Time Warner cable?
A cable signal.
What is any kind of signal that carries information that can be detected?
Chemical
I live in cookstown, what type of signal do I have Is it digital I find my picture quality to be poor & was wondering if a cable booster would help. If so does Rogers sell them?
The kind of signal you have would depend on who your service is through and what kind of service it is, and yes Rogers has a 'signal booster'.
Will you get a clearer picture or faster signals with a more expensive HMDI cable?
The bottom line is 'no'. HDMI delivers a digital signal, as in 1's and 0's. There is no room for the kind of signal degradation that plagues analog connecton.
Why do you have 'no signal' when you have plugged in the connections?
There are multiple reasons including damaged wires, network ports were disabled, cable is designed for a different kind of network, your firewall is not configured properly and so on.
What kind of cable is needed to connect VGA to RCA?
VGA, a computer video output, cannot be converted to a composite (1 video wire) or component video (3 video wires) signal with just a cable. VGA can be much higher resolution than composite video. You will need a scan converter box to create the NTSC video signal.
What kind of tissue carries oxygen round the body?
Blood carries red blood cells which carries blood around your body
My Direct T.V. dish is roof mounted . Over the years trees block signal . How far in length can the cable be w/o degrading the signal when having to use a ground mount . Is a cable amp needed over a certain distance Thanks f. Marshall Dublin Ga?
i am a direct tv tech. your cable should not exceed 150ft.direct tv uses low line voltage(13v and 18v) so no signal booster or signal amp can be used. use of any kind of booster or amp will ensure your dtv system will not work and may even be a fire issue. a 4 x 8 powered multiswitch from direct tv will keep strong signals with cable upto 150ft. J.Davis,North East,MD I've gone 20ft and no problem. If you have a good cable it will go longer.
What kind of cable to hook the 2nd computer into the router?
Ethernet cable
How can I get cable without a cable or satellite service available.?
Contact the cable company, and sign up. Pay for your cable. The existing wiring in your apartment is acting as a sort of off-air antenna. There are probably pretty strong off-air signals available in your area. If you don't want to sign up for service through cabel or satellite, then you may want to add some rabbit ears. Radioshack has some good ones that will strengthen the signal and aren't too big. If you are able to get some kind of signal through the cable jack, an RF amplifier may be able to boost the weak signal enough to produce a clearer picture. An RF amplifier like that used to boost an antenna's signal might work. Some of your cable signals may be out of the frequency range for the antenna amplifier to boost all of the channels. Don't expect any miracles like a crystal clear picture.
