answersLogoWhite
Heater Cores and Blower Fans
Mazda 626

The AC blower fan on a 90 Mazda 626 does not come on at all Can anyone give some reasons why?

303132

Top Answer
User Avatar
Wiki User
2005-11-04 16:53:47
2005-11-04 16:53:47

Go in the fuse box, below the hood, locate the ac fan relay (according to the schematic), swap it with another one(with an equal votage and amp value). start your car and turn on your ac. Then leave your engine runing. pop the hood and check if the fan is running. If the fan works, your ac relay needs to be replaced. good luck!

1

Related Questions

User Avatar

Why has my immobizer come on in my Mazda 6 and how can I turn it off

User Avatar

Blown fuse, defective blower motor, or defective blower motor resistor pack.

User Avatar

Is it the blower motor or is it the fans in the front?if its the fans they will come on at anytime to help cool engine down better.If its the blower motor for the interior heat and air you got a electrical problem. Is it the blower motor or is it the fans in the front?if its the fans they will come on at anytime to help cool engine down better.If its the blower motor for the interior heat and air you got a electrical problem. If it is the blower motor for your heater then it is definatly you blower resistor

User Avatar

The blower fan might not come on because the temperature sensor is damaged or malfunctioning. It also might not come on because of an exposed wire or a blown fuse.

User Avatar

Have your blower motor resistor or blower motor checked out

User Avatar

nobody (anyone can come, nobody can come.)

User Avatar

Mazda is a Japanese car company based in Fuchu, Aki District, Hiroshima. Mazda was founded in 1920 by Jujiro Matsuda.

User Avatar

to get more air in to the carb, rather than having to come in from the front of the vehicle, it goes through the blower to the carb

User Avatar

look on the firewall and there should be bolts that come out around the blower motor and then it just pulls out.

User Avatar

The heater blower may not be working properly. Without the heater blower working, the air will not come through the vents.

User Avatar

The last year that the Mazda RX-7 was made was in 2007. Mazda has now come out with the more edgy Mazda RX-8, which is a big hit with consumers.

User Avatar

Blower is about to die. I had same symptoms. Blower would not come on so I would run over bumps then it would engage. Replace blower no problems since.

User Avatar

The disconnect on the passenger side vanity mirror caused the dome lights - radio - auto locks to be come inoperable - has anyone had the experience and what is the cure?

User Avatar

If there is current going through the wire to the blower switch, try bypassing the switch with a jumper wire. If the blower motor works, then replace the switch. If the blower motor does not come on, then you probably need to replace the blower motor.

User Avatar

The blower motor usually doesn't come apart, as the internal parts are not usually sold separately.

User Avatar

Your inside blower motor is most likely bad and if not then check the capacitors and the wiring, but I would go with the blower.....

User Avatar

Mazda cars are going to come to India. It will arrive after the auto show of 2012.

User Avatar

There are many different reasons why he personally did not want to come out of his house. Many infer that the reason he did not want to see anyone else is that he didn't want to get into problems with anyone else and be a burden.

User Avatar

on the bottom passenger side under the glove box remove the cover, locate the blower motor, disconnect the plug from it, remove 3 screws and the blower motor should come out.

User Avatar

The blower resister is not supposed to be grounded. The smoke may be steam from a leaky heater core.

User Avatar

On my 1993 MPV the relays are located passenger side behind the fuse box next to the firewall also there is a 15 amp fuse. I replaced both relays on mine fan still doesn't come on?


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.