With computerized systems, in normal circumstances, the computer uses more than one input to control the ignition. These include a camshaft position sensor, and a crankshaft sensor. They are both needed, as one is used to determine the speed of the crankshaft, while the other is used to determine the position of the camshaft, which allows the computer to determine which spark plug to fire. When one fails, lighting the checjk engine light, the computer defaults to using the other sensor for both engine speed and position. This typically causes a delayed start, but if the computer gets lucky, it gets the engine started. When you reset the light, you are also telling the computer that the problem has been fixed, and makes the unit "look" again at both sensors. If only one works, the computer will wait for that fact to be "recognized" before again using only one sensor. In the mean time, the computer, "seeing" only one sensor, will not turn the ignition back on lest a backfire damage the engine or other component. This default set up is a line in the software controlling the computer. Ray
The pull cord of a lawn mower is used to manually crank the engine to get it started. As the engine is quickly turned, a spark is created which begins combustion.
Be it three phase or single phase, larger motors should be started with a magnetic contactor.
It is not supposed to be on when engine is running unless there is a problem.
The women started getting high on crack and then eating people. Then the ottomans turned them into zombies to take over the world
You're lucky.
he turned 11 yesterday...July 14, 1998 is his birthday!
If you put gasoline in your diesel engine, first be sure to keep the engine turned off. If you have already started the engine, turn it off. Then, drain the fuel tank, remove and replace the fuel filter, and fill the tank with diesel. This should fix the problem.
On most vehicles, after the problem is taken care of, the check engine light resets automatically after the ignition is turned off and then the engine is started again. If you have fixed one problem, a second problem probably exists.
There is a fuel pump relay underneath the fuse box in the pasenger side of the engine compartment. This relay gets stuck and does not open when the ignition key is turned off or after the engine is started.
Blown head gasket
Skate boarding was invented in California for surfers. When the waves were bad, surfers went "sidewalk surfing" down hills. Then kids started getting creative with them. They started doing tricks with them and eventually, it turned into what it is today.
Jaden Smiths birthday is July 8th 1998 and he just turned 13 yesterday.