Chevy Beretta

The reverse lights on a 94 beretta z26 are not coming on new bulbs and fuses where is the switch on the tranny located?

012

Top Answer
User Avatar
Wiki User
Answered
2008-09-01 16:57:18
2008-09-01 16:57:18

The neutral safety switch is what controls the reverse lights.

It is located on the top of the transmission almost directly below the brake master cylinder.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


Where is the fuse located for the reverse lights


The problem is the reverse light switch. It is located on the top of the transmission that should sloved your problem.


Where is the switch located for the back up lights on a 2000 cadillac daville


The reverse lights automatically come on as you put the car into reverse , if they are not coming on your most likely problem is the fuse or bulbs



if all other lights are working, i would start with the reverse light switch.this is usually located on the side of the transmission


Pull the turn signal towards you, push it back to turn them off.


for reverse lights, check the reverse light switch that is located on the transmission. for fog light, check bulbs, or broken wires for reverse lights, check the reverse light switch that is located on the transmission. for fog light, check bulbs, or broken wires


Reverse switch defective or loose. Located somewhere on the shifter. Check your fuses.


It's most likely the reverse/neutral safety switch located on your transmission



Both a stuck reverse switch and shorted wiring can be causes for reverse lights to stay on. Under normal circumstances, the reverse lights turn off as soon as the vehicle is shifted out of reverse.



Try bypassing the reverse light switch that plugs into the transmission. If your reverse lights come on, voila! Problem solved. Buy a new switch.


on my 1986 golf 2,(think its the same engine), its located on top of the gearbox.


Bad bulbs can be the cause of your reverse lights not working on your 1999 Toyota Tacoma. A problem with the reverse switch or bad wires can also be the cause of your reverse lights not working.


the reverse safety back up switch is located on top of the transmission next to the clutch resivior


there is a reverse light switch that you can purchase it is pretty much plug and play. it is located on the side of the transmission housing



If your reverse lights are not coming on when you put it in reverse there is a good chance that your neutral safety switch is shot. Check this link for information: http://98jeepbuild.blogspot.com/2009/06/neutral-safety-switch.html


If both ligths are not working at the same time it could be a bad switch that turns the lights on or it can be a bad gound under the car. Follow the wires that come fromt he reverse lights and see if you can find a possiable brooken wire or damaged wire. Hope this help you



The reverse light sensor switch on the gearbox needs replacing. The switch is normally located on top of the gearbox & around the middle of underneath the air intake box.


switch on the transmission which sends a signal to the reverse lights when shift is in reverse......... is shot. You need a mechanic.


There is a switch called the reverse backup light switch attached to the shifter. When you move the shifter into reverse, the switch is closed and current goes back to the reverse lights. The switch is located on both auto and manual trans. After making sure your bulbs are good, that is where I would look. And make sure your fuses are not blown as well in your fuse block. There usually is not just a circuit dedicated to reverse lights only but there is always something a manufacturer will do some years just to be different.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.