Start with the simple things first. It is possible that both reverse lights are burned out. Take your lens covers off-pull the light bulbs and replace them with new bulbs. they are cheap. It is also possible that moisture has gotten into the sockets because of bad lens seals and corroded the sockets preventing the lights from working. Clean out the corrosion, lightly grease the inside of the sockets, seat the bulbs. Before replacing the lens covers run a small bead of flexible silicone type sealer around the lens seats to prevent any further intrusion of moisture. Be sure not to tighten the screws too much or it will damage the plastic lenses which are usually brittle with age. Hope this helps! also inspect wires look for cracks in wires or corrosion
Bad bulbs can be the cause of your reverse lights not working on your 1999 Toyota Tacoma. A problem with the reverse switch or bad wires can also be the cause of your reverse lights not working.
if all other lights are working, i would start with the reverse light switch.this is usually located on the side of the transmission
switch on the transmission which sends a signal to the reverse lights when shift is in reverse......... is shot. You need a mechanic.
check for blown fuses
have you checked the bulbs and fuses
burnt out lightbulb!
The 2002 Cavalier has a reverse light switch. The switch can be bad, or have a loose connection causing the lights not to work.
Blown fuse, failed bulbs, bad switches, etc.
for the tail lights all the other lights are working blanking lights brake lights and reverse lights but no tail lights on both side
I remember early 50's as an option. 50's Ford products worked a little differently than GM and Chrysler. Ford products reverse lights were connected to the parking/headlights. The lights had to be on and the transmission placed in reverse for them to operate.
Could be the brake light switch or fuse.
There is a backup switch in the gearbox. When you shift into reverse, the gear box switch contacts the switch and lights the white reverse lights. If you find that the reverse lights don't work it could be that the switch is not being triggered by the mechanism inside the gearbox. This is providing that everything else is working; wiring,bulbs,etc.
Where is the fuse located for the reverse lights
Did you check the light bulbs? If OK, probably a bad reverse light switch in tranny.
Check your fuses
It may be the reverse light switch that need replacing, which is on the transmission.
Probably in the shifter wire loose or off.
the fuse is blown. they are on the same fuse
If the reverse lights are not working on a 1999 Chevy Suburban, be sure to check the fuse panel. If all the fuses are in working order, check the wires for any loose connections. Faulty wires can result in little or no light input.
Both a stuck reverse switch and shorted wiring can be causes for reverse lights to stay on. Under normal circumstances, the reverse lights turn off as soon as the vehicle is shifted out of reverse.
Check the bulbs, check the fuse then check the switch.
Try bypassing the reverse light switch that plugs into the transmission. If your reverse lights come on, voila! Problem solved. Buy a new switch.
have you checked the reverse lights switch?
for reverse lights, check the reverse light switch that is located on the transmission. for fog light, check bulbs, or broken wires for reverse lights, check the reverse light switch that is located on the transmission. for fog light, check bulbs, or broken wires