The tail light bulbs are on a different circuit than the signal light/stop light bulbs. Check for a burnt fuse or a loose wire.
Check the fuse for the headlights. It is probably open.
the brake lights are on a separate cuircut,if your brake lights are staying then it will be a fault with the brake light switch. the switch is located under dash,and will be on or very close to brake pedal.
i was wondering whether the switch at the parking brake could affect this problem.
Bad socket? Bad ground? Problem in steering column switch?
put the parking brake on the first click. it wont engage the brake but will turn of the lights but if you have a stock radio it will start beeping at you as soon as you hit about 10mph
Nonfunctional Brake LightsOne possible cause of this issue is that the brake light switch is not adjusted properly, or the switch could be defective.
Is it the taillights or the brake lights? If taillights it may be a wiring problem, If brake lights check the switch on the brake pedal
The brake lights and the tail lights are separate circuits. Check the brake light fuse, then check the brake light bulbs, then check the brake light switch.
Sounds like the brake light switch is defective.Sounds like the brake light switch is defective.
its just a fuse, look for a fuse panel there are two. one under the dash and the other under the hood.
on the brake pedal under the dash is a brake light switch. that when you depress the brake it turns your lights on. you might wanna check that
Check the bulbs one of the 2 filaments may be burned out