American Cars
Head Gaskets and Valve Covers

Torque specs on head bolts?

343536

Top Answer
User Avatar
Wiki User
Answered
2005-10-26 17:19:35
2005-10-26 17:19:35

Torque specifications are different from motor to motor. These specifications state how tightly the head bots are to be installed. Correct torque insure that the head gasket is sealed properly and correct torque sequence insures that the head itself is not warped in the installation process. Refer to a engine repair manual (Chilton's, Hayne's, etc.) for your vehicle/motor for the correct specs and torqueing sequence. You can usuall find these manuals at your local auto parts store. Hope this helps.

012
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Torque specs for a 1995 subaru impreza 2.2 head bolts?

The torque specs for 660 raptor head and hex bolts is about 26 lbs.

Torque specs can be found in the Haynes Auto Manual.

The torque specs for a Toyota Camry cylinder head is 60 pounds for the inside bolts and 50 pounds for the site bolts. The cylinder head bolts should be tight from and to end alternating.

What is the torque specs for Head bolts for 2003 Johnson 4 stroke 140 hp outboard boat engine

The torque specs for the cylinder head on a b2200 are 59-64 ft lbs (cold).

You should torque the head bolts by alternating from and to end, working towards the center. The head bolts should be torqued in 40 pound intervals.

what it the torque spec for head bolts on a 650 honda rincon 2005

What do you torque the head bolts on a 1998 nissan altima 2.4 l

The short bolt torque specs for the head gasket of a 2000 Pontiac Sunfire is 43 foot pounds. The torque specs for long bolts is 46 foot pounds.

most shop manuals have these specs in them. also, most head gasket manufacturers put the torque specs on the package. make sure you torque the bolts in the correct sequence also.

The cylinder head bolt torque specification is 90 pounds. The cylinder head bolts should be torqued in 30 pound intervals.

For the 1996 Chevy S-10 4.3 liter, the torque specs for the crankshaft damper bolts is 70 ft. lbs. For the cylinder head bolts, the torque is 65 ft. lbs, and for the engine mount-to-head bolts, the torque is 35 ft. lbs. For the engine mount-to-frame bolts, the torque is 52 ft. lbs.

134 ft-1bs is the torque for 94 civics

What is the head bolt torque for a 1997 chevy lumina four cylinder?

3.4 litre cylinder head torque is 37 ft lbs +90 degrees

Head bolts are 65 lb/ft. Look at the link, "Small Block Chevy" at the right for all torque specs.

first 22lbs then 47 lbs or 49lbs

torque especifications for Malibu 1999 3.1 engine

65 foot pounds for re-used head bolts and 72 foot pounds for new head bolts.

what torque specs on cam shaft bolts 2000 saturn 2.2


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.