the ignition switch is bad
One of the signal bulbs may have burned out.
For most vehicles the hazards and signals are two separate circuits, they have separate fuses and separate flashers. Check your signal light fuse and signal light flasher.
Probably the flasher unit needs to be replaced. This is an electronic switch which usually mounts underneath the dashboard.
Probably the Electronic Flasher. These ,when the fail,will allow the Signals and/or hazard lights to work intermittently. The flasher is the same for both the signals and hazards.
in electronics a Level shifter is use when u want take a Bipolar signal and feed it into a unipolar application. Ex. having a signal that swings from -10v to +10v and needing to feed it to a micro-controller that only takes values from 0-5v.
there is a constant buzzing from fuse box until signal or hazards are activated or until turn signal fuse is pulled
The switch on the brake pedal is disconnected or defective. The shifter interlock has to get a signal from the switch to know the pedal is being pressed before it will release the shifter.
cuz there broke.. try flasher or turn signal
replace turn signal flasher, hazard flasher is separate
Defective turn signal switch.
yes it will cause it doesnt use the signal to set the alarm or time.
if your right turn signal does not work then it could be the switch if not then it could be a wiring fault! Could also be turn signal flasher or switch in steering column as stated above