0
Red, 5 year, HOAT type.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Can you use premium gas on a 2004 jeep liberty limited?
You could, but you don't need to.
What do you need to hook up a tow bar to a Jeep Liberty?
you need to have a towbar and a Jeep Liberty
Where is a automatic transmission sensor located on a 2004 jeep liberty?
you need to take out the engine and its behind it, take it to a mechanic
How often should you change the spark plugs on a 2004 jeep liberty 3.7 L?
They should not need changing until 90,000 miles.
What size tire will fit on your 2004 Jeep Liberty?
There were 2 different wheel sizes installed on the 2004 Jeep Liberty. If you have 16 Inch wheels then the correct size tire for your vehicle is a 235/70-16. If on the other hand your Jeep is equipped with 17 inch wheels then you need 235/65-17 tires installed. Stick with the OEM size.
How do you change gas filter on jeep liberty 2004?
The 2004 Jeep Liberty has a "lifetime" fuel filter built into the fuel delivery module. This is located inside the fuel tank. The filter itself is not servicable. If you suspect a plugged filter, the entire module, which also contains the pump and level sender, will need to be replaced.
Where is the starter on a 2004 jeep liberty?
it is on the driver side just beneath the exhaust manifold. you will need to remove the exhaust or the cv joint to drop the starter
Why does my oil light keep coming on Jeep Liberty?
You may need to check the oil, or have the jeep serviced.
What does the error code p0700 mean on a 2004 Jeep Liberty?
Trouble code P0700 means: Automatic Transmission Control System Malfunction You need to check the TCM for codes.
How many quarts of oil you need for your jeep liberty to change oil?
5
Does the 2004 Jeep Liberty oil drain bolt need a washer?
why worry? just go to the dealer and order a new bolt. The original comes with a rubber type washer attached, so it must need it.
How do you change the taillights on a 2004 Jeep Liberty?
there are 2 torx head screws that hold the tail light on. you will need to open the back gate to get to them. then there are two snap connectors that hold the tail light to the body. you will need to pull straight back torward the rear of the jeep to get these to come loose.
