0
long life antifreeze coolant or and equivalent
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How do you remove the intake manifold on a 2004 Mitsubishi endeavor?
To remove the intake manifold on a 2004 Mitsubishi endeavor, you should take it to a mechanic. An authorized dealer will also fix it for you.
How do you take the key out of a Mitsubishi endeavor 2004 when it is stuck?
Step on the brake, press the lock on the 'Shift Stick' and push it to 'Park'.
Replace tail light 2004 Mitsubishi endeavor?
Take 2 screws out and pull light straight back, it will come over, replace bulbs and put back on and replace screws
Is the tire normally hard to pull off on a Mitsubishi endeavor?
You have to use a key to take tire off
How do you repair horn on a Mitsubishi lancer 2004?
To repair the horn on a Mitsubishi Lancer 2004 you should take your vehicle to the mechanic. You can also take it to the accredited dealer in the same.
How do you change the spark plugs on a Mitsubishi Endeavor?
Well the v6 engine will require you to take the intake off to get to the rear plugs but other than that it is pretty much the same
Where do you file a complaint regarding a paint problem with your new 2010 Mitsubishi endeavor se?
at the paint shop you got it done at or at the dealership you bought it from if they dont resolve it then you can take them to court.
How much antifreeze does a 2004 Dodge Ram 1500 Hemi take?
18.7 liters in a radiator flush and fill in a 2004 Dodge Ram 1500.
Where is the power steering pressure switch on a 2004 Mitsubishi Endeavor?
The pressure switch is located on the back of the power steering pump which is on the passenger side of the car at the rear of the engine. You can reach it from top or bottom but I found, to take it out it is easier to reach from under the car. It is the only part of the power steering pump that has a wire going to it.
What kind of antifreeze does a 2004 Saturn ion take?
Dexcool don't use any other type
How do you take apart barring assembly on 2004 endeavor?
I believe the "hub bearing housing" is one piece. Autozone.com has got some good diagrams of this.
How do you take off the intake on Mitsubishi Endeavor 2004?
Undo all the bolts that are holding it on. It is a pain and will take a while. There are two bolts in the back that must be accessed from underneath the car to get them off. Just take your time and remember where all the bolts went. The belt cover on the left hand passenger side of the vehicle will also have to be removed I think. Just remember take your time and don't tug on it. It will come loose if everything is disconnected properly.
