Chevy Astro
Buick Skylark
Ford Expedition XLT
Ford Ranger XLT

What are some possible problems on a 1993 Buick Skylark 3300 that can allow the engine to rotate but not start and no trouble codes?

789

Top Answer
User Avatar
Wiki User
Answered
2006-10-28 03:48:21
2006-10-28 03:48:21

I took it to a shop. It was the crankshaft position sensor.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


I have a 1995 Skylark and the gasket was replaced about 4 years ago and I've had no trouble at all. It's a V-6 3100 engine.

picture diagrams of engine for 1997 buick skylark

Knowing the firing order of a car's engine can help with diagnosing engine problems. The firing order of a 1971 Buick Skylark is 1-8-4-3-6-5-7-2.

yes it could cause big problems in your car. Id try and get it it fixed as soon as possible if i was you.

If you mean the engine, yes. The actual car, no.

You don't say which engine or year but see my post under "How do you change a serpentine belt on a 93 Buick Skylark" for a possible answer.

Because both computers have detected problems and set trouble codes.

Yes, you need to have the engine and transmission computers checked for trouble codes. That should lead you towards a possible cause.Yes, you need to have the engine and transmission computers checked for trouble codes. That should lead you towards a possible cause.

There are several reasons why a vehicle may shake. The basic reasons for this are engine trouble, axle problems, brake trouble, wobbly wheels or tire trouble.

check obd2 with scanner for trouble codes find problem, fix or replace sensor or part, clear codes with scan tool

Check the fuse or the bulb???

many of general motors engines are interchangeable, if the transmission was not replaced, then its a matter of possibly relocating motor mounts, and if 3300 s the original motor you shouldn't run into any clearance problems

Need more info check engine light on?trouble codes?year ?

The power of the engine and the maximum speed of the 1977 Buick Skylark manual are 220 hp at 4400 rpm and 250 km/h respectively.

The check engine light comes on when the engine computer detects a malfunction and sets a trouble code.You need to have the system checked for codes with a scan tool to know possible causes.The check engine light comes on when the engine computer detects a malfunction and sets a trouble code.You need to have the system checked for codes with a scan tool to know possible causes.

It is hard to trouble-shoot your problems as you don't mention any kind of symptoms. You need to list the symptoms (stalls, shakes, misses, engine light is on, etc.) in order to lead you in the right direction for trouble-shooting. However, if the check engine light is illuminated, you can take your vehicle to AutoZone or similar suto parts store and they will scan for trouble codes free of charge.

low pressure side on a buick skylark with a 2.4 engine is by the compresor. you get to it from under the car. left side, front side of engine.

I have a 1995 Skylark and that repair is at least $500.00 but it's worth it. The engine runs great now.

It may stall and refuse to start if the ignition gets wet.

The check engine light comes on when there is an emissions related failure. You need to have the system checked for trouble codes to know possible causes.

Two different problems. You need to pay more attention to basic engine maintenance.

Refrigerant for a 1996 Buick Skylark is inserted into the low pressure AC hose. This hose is found on the left side of the engine bay.

The thermostat on a 1991 Buick Skylark is located near the engine. To find the thermostat, follow the top radiator hose directly to the thermostat.

If it is a 3.1L V6, 1994 Skylark you have to remove the top engine mount in order to get the belt off and them back on. You must support the engine from the underside. Use a block of wood between the pan and the hydraulic jack.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.