I'm not sure how familiar with auto repair you are, so I'll try to explain it as simply as I know how. It sounds to me like a distributor module. This is a little black box (if you will) that sits under the distributor cap. It's really easy to replace. Take the distributor cap off, and it should be there with two wires connected to it. It's only held in place by two small bolts. It can be tested at most any auto parts store. They're also fairly inexpensive to replace.
Low compression, weak spark or poor fuel delivery can make a vehicle more difficult to start in the cold.
In the intake behind the throtle body.
IT starts @ the intake manifold & ends on the front axle.
Possibly clogged fuel filter
Chrysler Corporation does not install inertia switches in their vehicles. It is probable fuel pump, fuse, or relay.
305 is a 5.o liter
No , just the 2.3 liter 4 cylinder or the 5.0 liter V8 engines were available in a 1989 Ford Mustang
where can i find a vacuum line diagram for 1989 ford 2.9 liter engine
No.
There is no 2.8 Liter in a 1989 Ford Ranger. The Ranger V6is a 2.9 Liter and the distributor rotates clockwise.
There is more then likely loss of compression, resulting from a number of reasons, do a compression test.
The 2.2 liter 4 cylinder and the 3.0 liter V6.
.035 in a 1989 k 2500 truck.
Where is the fuel pressure regulator located on a 1989 chevy silvarado with 5.7 liter engine
You can fit the remanufactured 18 liter Ford engine in the 1989 Tempo. You can also choose the 3.0 liter SHO engine that was found in the Escort at about the same time.Ê
It does not have 1.
( .044 inch ) for the 2.3 liter four cylinder engine in a 1989 Ford Mustang ( according to one of the Ford websites )