Auto Parts and Repairs
Brake Pads and Rotors
Ford Expedition XLT
Honda Civic EX

What are step by step instructions to replace drum brake pads on a 1991 Ford Festiva?

444546

Top Answer
User Avatar
Wiki User
2004-10-13 10:17:22
2004-10-13 10:17:22

Get a manual from DISCOUNTAUTOREPAIRMANUALS.COM for about $9

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

www.techcapri.com has instructions on this.

User Avatar

Buy the Service Manual and follow the instructions.

User Avatar

Remove the light assy and screw it in from the rear.

User Avatar

To change the brake rotors on a 1991 Honda Civic raise the vehicle. Remove the wheels and brake caliper bracket. Remove the brake pads. Loosen the rotor mounting screws and replace the rotors.

User Avatar

I am looking for the bulb number to replace a burnt out bulb on a 1991 Toyota pickup

User Avatar

How to Install Front Brake Pads Check related link below

User Avatar

There could be many causes to a brake light not working. It is best to replace the fuse, and the bulb and check the wiring.

User Avatar

3.6 Quarts (including filter)

User Avatar

Should be at the upper end of the brake pedal under dash area Should be at the upper end of the brake pedal under dash area

User Avatar

This site has good instructions on how to do it on many different cars. Instructions for the Accord is towards the bottom of the page: http://www.ecmtogo.com/removing_ecm.htm

User Avatar

Step by step instructions for Alternator replacement can be found at; http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528006183d

User Avatar

Each brake line is held in place with a swivel nut at each end. Turn the swivel nut to the left. The brake line will come off.

User Avatar

You can fix the brake booster switch in your 1991 Jaguar by replacing the brake booster switch. In most cases when the brake booster switch does not function properly the only way to fix it is to replace it.

User Avatar

How to change brake lines on a 1991 Buick Lesabre?

User Avatar

how do remove the brake drum on a 1991 mazda 323

User Avatar

Brake jobs are not a job to be done without a Manual.Your life and the lives of others and the life of your Automobile depend on them. Please purchase a [http://www.themotorbookstore.com/index.html Paper Repair Manual] OR a [http://www.themotorbookstore.com/manuals-on-cd.html CD Repair Manual] and do the Job correctly.

User Avatar

It's right on the hand side of the motor, under the distributor.

User Avatar

The switch is located down by the foot petal, near the brake booster shaft that pushes the master cylinder. Its not fixable, if it is inoperable, you replace it.

User Avatar

behind the engine, next to the brake booster, a ring of 7mm screws finess it out wriggling it a little. replace the control module at the same time!!

User Avatar

This link has photos and steps to replace brake pads and rotors. http://www.explorerforum.com/forums/showthread.php?t=122696

User Avatar

its on the left hand side of the steering wheel for the turn signal

User Avatar

A 1991 Jeep Wrangler uses DOT 3 brake fluid.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.