if its h22a engine intake are 0.15-0.19mm (0.006-0.007in) ,exhaust 0.17-0.21(0.007-0.008)
At the factory we set the tappet clearance to 200 microns plus or minus 20 microns. This applies to all L4 and V6 engines. The Prelude is built in, but I would assume that the settings are the same.
Please reask question: Where are the VALVES ON A 1989 HONDA? How many VALVES ON A 1989 HONDA? How do I adjust the VALVES ON A 1989 HONDA?
The exhaust valves should have .005 inches of clearance, and the intake valves should have .004 inches of clearance.
Intake and exhaust valves have the same clearance: 0.10 mm (0.0004 in).
Honda Prelude was created in 1978.
Yes you can I have 1988 Honda prelude with the 2.0L in it.
No, the Honda Civic springs is not compatible with any generation of the Honda Prelude.
Honda stopped making the prelude in 2001.
Does a 1998 Honda prelude have a clutch cable
As of this writing, there are no reports that the Prelude model will be revived by Honda.
Yes, the fourth generation prelude should have identical hoods regardless of the year. Call your local dealer or consult a OEM parts vendor to make sure the parts numbers match.
How to you syncronize a 1984 honda prelude carburator?
Make: Honda Model: Prelude... what are you really asking?
The 1986 Honda prelude 2.0 Si has a A20a3.
The H22 engine, which are found in 1997 Honda Preludes, are interference engines. This means that the valves and pistons do indeed make contact as the engine is on.
No, the 88 and 93 are a different chassis.
How do you replace the fuel pump Honda prelude 1992
Since its inception, the Honda Prelude has been categorized as a sports coupe.
How do you change a fuel filter in a 1997 Honda Prelude
The 1986 Honda Prelude does not have a clutch cable. The 1986 Prelude has a hydraulic clutch instead of the clutch cable.
You change the timing belt at 100,000 km. you can do it at 90,000 just to be on the safe side. If it breaks you can bend your valves
No, the third and fourth generation are a different Chassis.
I have an 88 Honda prelude and my computer is located under the carpet on the passenger side.
More information is needed on this...is it a stock Honda alarm? What year (or generation) Prelude is it for?
Adjusting the valves on a 1996 Honda Accord is relatively simple. First the valve cover needs to be removed, and using a special measuring gauge check to factory manual to choose what clearance levels are needed. Proceed to tight or loosen the valves as needed.
can't tell much from the question but if you want valve clearance setting it is .002in. on the intake and exhaust valves