When a door drops down it usually is bacause it needs a hinge bushing. However, if everything's OK there's two things you can do. 1. Easiest method. Put a jack underneath the door and bend it back up. Unless the hinge has slipped, that's why it's down there anyway. 2. If applicable, loosen the hinge and adjust the door up.
If it is an automatic you have to remove the pan
More than likely it is out of time. Have the timing checked. If you have changed the plugs or plug wires, you have them hooked up wrong.
Answertiming out of adjustment. start with distributer timing and go to timing belt or chaincould be the crank position sensor located behind the harmonic balancer
the best way is too call a big savage yard they can tell you what parts interchange for sure instead of people guessing on here
maybe this will help,,, i just replaced the water pump,heater core,thermostat,battery,alternater on my Oldsmobile and found this site to be very helpful even has pictures AutoMedia.com maybe you can find your answer there good luck
Disconect the negative terminal & put a test light in line-& start pulling fuses until the test light goes out.when U get 2 the fuse that turns out the test light-THAT is the Circuit u start 2 trace.make sure the light is inlne-NOT having the battery cable touching the battery post.just the light - inline.
state 2 procedures should be used to properly handle a light microscope
Software that allows your hardware to function properly.
Diaphragm and Light scurce.
diaphragm and light scurce
Documents and training that enable people to do their job properly.
You can use the equipment properly, this lengthens the equipments life span and you can store it properly and in the railway there are items of equipment which if you dont store them properly will make them get faults with them and make them unuseable.
To ensure the operating system function properly
It is properly issued by the state, and it is not past its expiration date.
The questions in the Kentucky state drivers permit test contains questions regarding driving rules, regulations, procedures, and highway signs.
Usually it's caused by not properly working drivers. Check the laptop manufacture website for new drivers.
Most drivers don't grow beards as it may stop the helmet from fitting properly. Drivers who attempt to race without a helmet will be disqualified. It is also uncomfortable to wear a helmet over a beard.
You get your computer to recognize a DVD writer by ensuring the correct device drivers are installed and properly. Without drivers, the computer will treat it as an Unknown Device.
If the updating software is working properly then the old drivers will be overwritten by the new ones. This especially true if you are doing a 'clean install'
It means that your network controller is working properly. Make sure that you have installed proper drivers and the card is sitting properly in the slot.
Traffic accidents happen because of:weather conditionshigh speedreckless driversdistracted or inattentive driversIn the workplace accidents can generally traced back to:Failure to follow proceduresLack of trainingFaulty equipmentWorker errorMislabeled equipmentUnsafe conditionsManagement failure to require that procedures be followed