1991 toyota camry head bolts torque specs
The torque specs and pattern on the head bolts for a 1991 Toyota pickup with a 3.0 EFI is 50 foot pounds per bolt. The pattern is 4,5,6,3,7,2,8,1 with 1 being at the front of the engine.
The torque specs and pattern on the head bolts of a 1991 Toyota pickup with a 3.0 engine are 5, 4, 6, 3, 2, 7, 1, and 8. This sequence is started from the center of the head and requires 75 foot pounds of torque on each bolt.
torque specs of what?
The cylinder head bolt torque specification is 90 pounds. The cylinder head bolts should be torqued in 30 pound intervals.
the head bolts are tightenend to spec in 2-3 steps and go from 18-37
Need more info. Torque specs. for what?
The 1991 Buick 3.1 liter rod cap torque specification is 90 pounds. The rod bolts should be torqued in 45 pound intervals.
Depends on the bolt size. 8mm bolts are 17-18 ft lbs or 204-216 in lbs, 10mm bolts are33-35 ft lbs or 396-420 in...
60-to 70 ft. lbs. of torque 60-to 70 ft. lbs. of torque
The thermostat just sits there in the housing. The housing should be bolted down with two 3/8-16 bolts that are tightened to 45 ft/lbs.
what is the over all torque for a Mercedes 300e 1991
Remove the transmission and starter. Unbolt the flexplate from the crank. While you're at it, replace the rear main seal. Replace the flexplate and torque bolts to manufacturer's specs.
if it is a GT there are no specs just tightend down..hope this helps http://foxbodychallenge.com/node/20 <- here is a list of all torque specs for mustangs. hope that helps
what is the torque on the bolts for the transmission pan on a 1991 ford thunderbird 3.8
There is no torque sequence just torque rocker arm studs to the proper torque
160 foot lbs
100 foot pounds
65 foot pounds.
1st 35 FT. Lbs. 2nd allan additional 130 degrees. 3rd step are the 4 center bolts turn additional 30 degrees.
The torque specs. are 45 Ft- lbs. If its a 1991 engine its 20 FT-lbs first then turn each nut additional 60-degrees.
Local library\ shop manual/ also parts store has head specs for when they sell gasket:)