Recommend purchasing a shop repair manual fir that vehicle if you want to DIY.
Verify that the clutch is working. If there are noises, there is a problem. Disconnect the negative charge. Lift the vehicle up and support it. Support the engine with a hoist. Disconnect clutch linkage. Remove the clutch and replace it.
If you need to replace the slave cylinder it is located in the bell housing and the trans has to be removed. The clutch master cylinder is located on the firewall on the drivers side
where is the location of tensioner of 2002 3.1 L Chevy Malibu to adjust if replacing the alternator?
Take out the battery, unbolt and remove the battery tray. This will expose where the ground is. Unbolt that. Replace in reverse order of the above steps.
There are seven steps on how to replace the EGR valve in a 91 Chevy Corsica. Some of the step-by-step instructions are disconnect the car battery, unhook the air supply hose, and remove the EGR mounting mounting bolts with a socket wrench.
To many steps involved to list here. I would suggest purchasing a shop manual for that vehicle if you want to replace the heater core yourself.
no extra steps at all, as long as you dont need to replace parts that need bleeding
The 1987 is a b2200 NOT a b2600.Next to remove the fan clutch I suggest removing the fan shroud very easy for extra room.the fan clutch is held on with 6 ten millimeter bolts.Unbolt and it comes forward and simply reinstall new fan clutch.I may be leaving some steps off but this should be correct.
Look on the back side of the bumper find the socket turn it, remove the bulb replace it, reverse steps to reinstall it
follow these steps 1. take out battery 2. take out fan your gonna need the room 3. take out starter 4 take out transmission 5 use the ailgnment tool that comes with the new clutch. 6 take out clutch with alignment tool and then 7 replace pilot bearing you are gonna have to take out the fly to do this 8. replace fly wheel with new pilot bearing and insert new clutch and pressure plate 9 on the inside of transmission housing there is a clutch release bearing u have to change that after that 10 reserve order steps 1-4 i just got through doing mines any questionemail me rscott12@yahoo.com
Drain the radiator. Remove the top hose, and the water inlet. Remove the thermostat from under the inlet, and replace it. Reverse the steps to finish the installation.
To many steps to list here. If you intend on doing this job yourself I recommend purchasing a shop manual for that vehicle. It will be worth the investment.