0
What are the symptoms of a bad axle for a 1998 Chrysler Concorde?
Wiki User
∙ 10y ago
Will not move, shake on acceleration, or a popping noise during turns.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
What socket is needed for the front axle nut of hub on a 1998 Chrysler Concorde?
34 mm metric socket. They cost under teen bucks
How do you remove rh front axle from transmission on 2001 Chrysler Concorde lxi?
How do you remove rh front axle from transmission on 2001 chrysler concordeRead more: How_do_you_remove%20lh_front_axle_from_transmission_on_2001_chrysler_concorde_lxi
What socket is needed for the front axle nut for the hub assembly on a 1994 Chrysler Concorde?
inch and a quarter or one and five sixteenths
What is the touque on dodge drive axle?
The Chilton Manual for Chrysler Concorde, 300M and Dodge Intrepid years 1998 to 2001 says the torque specifications for the driveaxle / hub nut is 120 foot pounds for years 1998 and 1999 and 105 foot pounds for years 2000 and 2001. Hope this helps.
What type of axle is on a 96 Jeep Cherokee?
The 1996 ( most other model years ) Jeep Cherokee has either the DANA 35 rear axle or the Chrysler 8.25 rear axle. ABS brakes are optional with the Dana 35 . The Chrysler 8.25 never had ABS. The front axle is the DANA 30.
What does Corporate 9.25 LD Rear Axle mean?
It is a Chrysler built axle with a ring gear diameter of 9.25 inches.
What would cause the axle on a 96 Chrysler to separate?
Motor mounts.
Does 1998 dodge Chrysler 360 has speedometer and odometer cable?
No, the speed signal comes from the ABS computer via the rear axle speed sensor.No, the speed signal comes from the ABS computer via the rear axle speed sensor.
How do you replace the front hub assembly on a 1998 Chrysler Town and Country?
This is extremely easy. Unscrew axle nut, which is held on with 140 lbs of torque, then unbolt 4 bolts holding assembly inplace, slide assembly off axle splines, install in reverse order.
How do you identify the rear end of a 2005 Dodge Ram 1500. Tag says 9.25 and gear ratio is a 3.55 but is it a Dana rear end or a Chrysler?
The 9.25 rear axle is a Chrysler corporate axle, it is not a Dana.
Does a 2005 Chrysler sebring have an u joint?
No the axle shafts use CV joints.No the axle shafts use CV joints.
Where is the spare tire on a 2006 Chrysler Pacifica?
Underneath the rear, behind the axle.
